Basic Operation
■Notes:
•Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 11 for details about operation.
•Before operating this receiver, first set this unit as desired for optimum performance, doing the setup procedures. (For details, refer to "SYSTEM SETUP" on page 18.)
ENGLISH
LISTENING TO A PROGRAm SOURCE
1. Turn the power on.
•Each time the POWER ON/STANDBY button is pressed, the unit is turned on to enter the operating mode (the POWER ON/STANDBY indicator lights up blue) or off to enter the standby mode(the POWER ON/STANDBY indicator lights up amber).
•On the remote control, press the POWER ON button to enter the operating mode or press the STANDBY button to enter the standby mode.
■Standby mode
This means that the unit is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
2. Select the desired input source.
•Each time the INPUT SELECTOR button on the front panel, the input source changes as follows :
→FM → SAT → TV → AUX → BD/DVD
(frequency display)
•Each time the “TUNER” button on the remote control is pressed, the FM mode changes as follows:
→FM ST → FM MONO
■Note :
•During playback of BD Video or DVD Video on the BD player, if an input source is selected and then BD/DVD is selected within 3 minutes again, playback will be paused on that point at which an input source is selected.
When SAT, TV, AUx is selected as an input source
3. Select the digital or analog input connected as
desired.
•Each time this button is pressed, the corresponding input is selected as follows :
→ANLG(Analog) → COAX(Coaxial) → OPTI(Optical)
■Note:
•When the selected digital input is not connected, the “DIGITAL” indicator flickers and the analog input is automatically selected.
4. Operate the selected component for playback.
•When playing back the program sources with surround sound, refer to "ENJOYING SURROUND SOUND" on page 17.
5. Adjust the (overall) volume to a comfortable listening level.
6. To mute the sound.
•"MUTE" is displayed.
•To resume the previous sound level, press it again.
7.To listen with the headphones.
•Then the “SPK OFF” is displayed and the sound from the speakers is cut off.
■Note:
•Be careful not to set the volume too high when using headphones.
14