Sherwood VR-654BD manual BD Player Section

VR-654(G)_ENG_100129_VR-654(G) 2010-01-29 오전 10:45 페이지 51

[BD PLAYER SECTION]
PROBLEm	POSSIBLE CAUSE	REmEDY
No playback	• The disc is loaded upside down.	• Reload the disc with the printed side up.
	• The disc is not playable.	• Use a playable disc.
			ENGLISH
	• The disc is dirty.	• Clean the disc.
	• The recorded disc is not correctly finalized.	• Load a disc that is correctly finalized.
	• The parental level is not set correctly.	• Set the parental level setting correctly.
		(Refer to “SETTING THE PARENTAL CONTROL”
		on page 44.)
	• The symbol about invalid operation is displayed.	• Adjust the setting correctly.
		(Refer to “SYMBOL ABOUT INVALID OPERATION”
		on page 25.)
Malfunction	• The disc is scratched, dirty badly or unplayable.	• Press the POWER ON/STANDBY button to turn the
		power off, press this button again and then unload the
		disc.
No picture	• The video cords are disconnected.	• Connect the cords correctly.
	• The incorrect selection of input source on the TV.	• Select the input source correctly.
	• The disc is not playable.	• Use a playable disc.
Noisy or distorted picture	• The unit is connected to a VCR directly and the	• Connect the unit so that the picture signal is
	copyguard function is activated.	transferred directly to the TV.
	• The disc is dirty.	• Clean the disc.
	• It is in rapid advance or reverse playback, or in frame	• Sometimes small amount of picture distortion may
	advance playback.	appear. This is not malfunction.
Abnormal picture or no	• The resolution is not set correctly for video signals to	• Set the resolution correctly. (Refer to “SETTING THE
picture	be output form the COMPONENT and the HDMI	DISPLAY” on page 42.)
	OUTs.
	• The TV does not support HDCP.	• This unit will not transfer the video signals via HDMI
		connector to TV that does not support HDCP.
		This is not malfunction.
	• The TV type of this unit is different from that of your	• Set the TV type correctly. (Refer to “SETTING THE
	TV or the disc.	DISPLAY” on page 42.)
Slight pause of picture	• The layer transition occurs during playback of DVD	• Sometimes slight pause may occur.
	Videos, etc. recoded in dual-layer format.	This is not malfunction.
Noisy or distorted sound	• The disc is dirty.	• Clean the disc.
BD-LIVE contents	• Poor connections between this unit and broadband	• Check the connections and connect all cords securely.
cannot be loaded	router and/or modem.
	• The USB memory device is disconnected.	• Connect the USB memory device to this unit.
	• The BD-Live Internet Access is set to “Prohibit	• Set it to “Always Allow Access” (Refer to “SETTING
	Access”.	THE SYSTEM” on page 41.)
	• The BD disc does not support BD-LIVE.	• Load a disc that supports BD-LIVE.
	• The network settings are not set correctly.	• Set the network settings correctly. (Refer to “SETTING
		THE NETWORK” on page 45.)

51