Samsung SRD-852D Setting the Monitor, Screen Setup, Move to Monitor, and press Enter button

using the DVR

Monitor

You can configure information to be displayed and its format for Spot Out monitor.

Setting the Monitor

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Device> window to
2.	move to <Monitor>, and press [ENTER] button.
	Select <Monitor>.
3.	Use direction buttons (	) to move to a desired
	item, and set the value.

•Event Display : Sets the dwell time of the event channel display on the monitor when an event occurs.

If selected <Continuous>, it displays the channel until you press [ALARM] button to release it.

•Display : Displays only checked items on the monitor screen.

Monitor
Monitor		Spot Out	Mode
x Event Display		OFF
x Display		Date	Time	CH Name	Icon
x Multi CH SEQ Time		5 sec
x VGA	800x600
x Sharpness	Level1 (Low)
Display Position Setup
		OK	Cancel

•Multi CH SEQ Time : Sets the interval between automatic display switching in 4-split and 9-split mode of the Live screen.

•Sharpness : You can adjust the sharpness of the video output signal.

4.When the monitor setup is done, press <OK>.

Screen Setup

Some monitors many not display information (camera name, icon, time information, etc.) about the DVR, depending on the condition. Then, you can change the display position of the data.

1.In the <Device> window, press the up/down ( ) button to move to <Monitor> and press the [ENTER] button.

2.Select the <Monitor> item.

3.Select <Display Position Setup> in the bottom.

You will move to the <Display Position Setup> window.

4.Use the four direction buttons or the number buttons on the front panel or the remote control to adjust the data position.

2011-01-01 01:10:25
Display Position Setup
	30
30	30
	30
OK	Cancel

50_ using the DVR