AG Neovo manual TSC-40/IC Product Specification

Page 7

TSC-40/IC Product Specification

*1: Auto transition = Mode changes by a command are not performed. It becomes a “Coordinate Data Mode (150pps)” immediately after reset.

*2: Always open. If connected with VCC, VSS, or other circuit, an error operation may occur.

*3: About pin number 14, 15 and 16, immediately after a power supply injection, it works as an input terminal and becomes an output terminal after that. Do not open these terminals.

*4: If neither SW0 nor SW1 function is used, connect 28 and 29 pins to GND directly.

Document No. DER-S0026A

6

Version 1.2 ©2008 DMC Co., Ltd.

Image 7

Contents Page Dimensional Drawing Circuit Diagram Table of ContentsScope of Application FeaturesOutline General specification Pin layout and representation Marking specificationEEP-DO Pin functionsTSC-40/IC Product Specification Power supply voltage setting Initial settingEeprom setting Touch screen mode settingAbsolute maximum rating Data sheetMaximum Recommended operational conditionsRST Timing requirementDC standards Basic packaging Packaging SpecificationSmall group packaging Product name label specification Tray specificationStorage Conditions Storage SpecificationBaking Soldering iron Manual soldering Implementation Temperature SpecificationReflow method Infrared reflow, air reflow Wave soldering method Flow soldering, solder dip methodCleaning Terminal Pin SpecificationVersion history Changes and improvementsWarranty Exceptions WarrantyWarranty Period Warranty TargetOthers Overall handlingPage