PROGRAMMING CABLE ID LOCK
The Atlas OCAP 5-Device Remote Control with Learning is locked at the factory to operate your cable provider’s set top box. However, if you have another brand or model of cable converter or satellite service that you would like to control, then you’ll need to perform the following steps to unlock the ID Lock, enter a new manufacturer’s code, and lock the ID Lock again.
1.Turn on the cable converter.
2.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until
the CBL key blinks twice.
3.Enter 9 8 2. The CBL key will blink four
times, indicating ID Lock is unlocked.
4.Perform the instructions under “Programming Device Control” on page 10 to program device control for the desired cable converter or satellite receiver.
When you are done, perform steps 5 and 6 on this page to again lock the cable ID Lock.
5.On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until the CBL key blinks twice.
6.Enter 9 8 2. The CBL key will blink twice,
indicating ID Lock is again locked.
PROGRAMMING MACRO KEYS
The Atlas OCAP 5-Device Remote Control with Learning includes two macro keys (located directly below the MUTE and LAST keys). Macro keys allow you to set up key macros to activate certain keys in a specific order. For example, you can set up a key macro to change the channels on your TV, raise or lower the volume, and start recording on your VCR, all with the touch of one key. If you want to change the macros stored in a previously-programmed macro key, you’ll need to clear the key first (see “Clearing a Macro Key” on page 21).
www.urcsupport.com/atlasocap
20
