Universal Electronics ATLAS OCAP 5-Device manual Checking the Codes, Using Learning

CHECKING THE CODES

If you have set up the Atlas OCAP 5-Device Remote Control with Learning by searching for your device code (on the previous page), you may need to find out which four-digit code is operating your equipment.

For example, to find out which code is operating your TV:

1.On the remote control, press TV once; it will blink once. Then press and hold SETUP until

the TV key blinks twice.

2.Enter 9 9 0. The TV key will blink twice.

3.To view the code for the first digit, press 1

once. Count the number of times the TV key blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box on page 11.

NOTE: If a code digit is 0, the selected mode key will not blink.

4.Repeat step 3 three more times for the

remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes on page 11.

5.To check for other device codes, repeat steps 1 through 4, but substitute the appropriate key (e.g., VCR, DVD, AUD, or CBL) for the device you are checking. Write down the codes in the appropriate boxes on page 11.

USING LEARNING

The Atlas OCAP 5-Device Remote Control with Learning includes a Learning feature so you can add functions that are unique to your home entertainment devices (e.g.,VCR Tracking Up or Down). However, there are some considerations.

Learning Precautions

•Your original remote controls must be in working order for learning to work properly.

•Learned keys are mode-specific, so each one can store a unique function for each mode.

•Do not use the following keys for learning: Device Keys, SETUP, Record (•), Tune-In Keys.

www.urcsupport.com/atlasocap

14