3.Press AUD once, then press VCR once. The VCR
key will blink twice.
The VCR key is now ready to be programmed for your second audio device. See “Programming Device Control” on page 10. To re-assign other device keys, repeat these and substitute the key sequence using the following chart:
NOTE: Only one device can be assigned to an unused device key at a time.
To Re-Assign | Perform Key Sequence |
VCR as 2nd | VCRSETUP992AUDVCR |
AUD key | |
| |
VCR as 2nd | VCRSETUP992TVVCR |
TV key | |
| |
VCR as 2nd | VCRSETUP992CBLVCR |
CBL key | |
| |
VCR back to | VCRSETUP992VCRVCR |
VCR | |
| |
To re-assign another unused device key, substitute it for the VCR key above and then perform the sequence. For example, to re-assign an unused AUD key as a second DVD key, perform AUDSETUP992DVDAUD.
When a re-assignment is done, the selected device key (e.g., AUD) will blink twice to confirm your choice. At that time, you will need to program device control (see “Programming Device Control” on page 10).
CLEARING CUSTOM PROGRAMMING
The Atlas OCAP 5-Device Remote Control with Learning contains a Custom Programming Reset program. You can use it to remove all custom programming, except your setup codes and reassigned device keys.
IMPORTANT: Executing this program will erase all cus- tom settings for Volume Lock, Learned Keys, Tune-In Keys, and Channel Lock. However, your device programming remains.
1.On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
