Sunwave Tech SRC-3810, 3815 manual

Page 58

SRC-38 SERIES User’s Manual

One or more devices do not respond in RF mode.

When operating properly, the red LED light on the front of the IR-extender will blink while sending or receiving signals. To test IR-extender:

1.Press Remote Locator button.

2.Use remote in RF mode.

LED should blink during each test.

RF addresses for device(s) and IR- extender may not set to the same setting. Check setting on each and reset of needed.

Check to make sure SRC-3815 is set to operate in RF mode.

IR-extender is not aimed at desired device. Reposition IR-extender.

No AC power to IR-extender. Make sure AC adapter is plugged in.

Batteries may be low in remote. Change batteries if needed.

52

Image 58

Contents SRC-3810/3815 031021Page Preface Table of Contents Iii Page Following list identifies the SRC-3810/3815’s key features SRC-3810/3815 FeaturesIntroducing the SRC-3810/3815 Unpacking the SRC-3810/3815 Identifying Components Backlight press this button to turn on the LCD backlightFor SRC-3815 Remote Control Battery Indicator Installing IR-extenderInstalling Batteries Getting StartedBattery Tips and Precautions Battery IconTurning the Touch Screen On Touch Screen PrecautionsAbout the Touch Screen Please read the following instructions carefullyEntering the Setup Menus Using Hard KeysTouch Screen Buttons Navigating the Setup Menus Entering the Setup MenusFallowing illustration shows the setup menu tree Setting Up the SRC-3810/3815 Device MenuCreating a New Device Follow these steps to create a new deviceRe-Labeling Devices Follow these instructions to edit a device labelAddr Setting RF Address SRC-3815 Device Menu Deleting Devices Code Menu Using Pre-Code to Program Devices Manually Selecting the CodeSelecting a Code Automatically Using Code Learning Mode Before Using the Learning FunctionLearning from Another Remote Control Erasing Key Codes Erasing Device Codes Debugging Device Codes All unrecognized codes should be sent to this addressCode Menu LCD Layout Using Macros Creating a New Macro Follow these steps to create a new macroPress the DVD play key Deleting a Macro Follow these steps to delete a macroViewing a Macro Follow these steps to view the steps of a macroMenu, press and to scroll through the menu options Setting Quick CHsSetting a Quick CH Follow these steps to create a new Quick CHDeleting a Quick CH Follow these steps to delete a Quick CHRelabeling a Quick CH Using the Transmission Feature Miscellaneous Menus Setting the Date and Time Setting the Power Down Time Setting the Backlight On TimeSetting the Beep Signal Resetting the SRC-3810/3815 to Factory Defaults Checking the Version NumberPage Controlling Devices Selecting a Device to ControlAlternating Touch Screen Pages Viewing the Macro KeyUsing the Quick CH Buttons Using the AUX Key Controlling DevicesAppendix a Specifications Model SRC-3810/3815Appendix B Accessories USB cableIR Blaster Cable SRC-IR for SRC-3815 Additional RF IR-extender SEL-6000 for SRC-3815Appendix C Troubleshooting Troubleshooting TablesRF mode Troubleshooting Tables