Sunwave Tech 3815, SRC-3810 manual Appendix C Troubleshooting, Troubleshooting Tables

Page 55

Troubleshooting Tables

Appendix C – Troubleshooting

Troubleshooting Tables

Problem	Solution
LCD does not show	Batteries may be dead. Replace the
anything when you touch	batteries with 4 new AAA Alkaline
it or press the hardware	Batteries (page 5). Check that the
buttons.	batteries are properly installed.
The SRC-3810/3815	Make sure that the desired device
doesn’t operate a device.	screen on the SRC-3810/3815 LCD
	panel has been selected.
	Move closer to the device. The
	maximum operating distance is
	approximately 30 feet.
	Ensure that you are aiming the SRC-
	3810/3815 directly at the device and
	that there are no obstructions
	between the SRC-3810/3815 and the
	device.
	Ensure programming with the
	learning function (page 20) or using
	the manufacturer codes (page 18)
	has been properly done. Re-teach
	the button.
	In IR mode:
	Move closer to the device. The
	maximum operating distance is
	approximately 30 feet.
	Ensure that you are aiming the SRC-
	3810/3815 directly at the device and
	that there are no obstructions
	between

49

Image 55

Contents 031021 SRC-3810/3815Page Preface Table of Contents Iii Page Following list identifies the SRC-3810/3815’s key features SRC-3810/3815 FeaturesIntroducing the SRC-3810/3815 Unpacking the SRC-3810/3815 Backlight press this button to turn on the LCD backlight Identifying ComponentsFor SRC-3815 Remote Control Getting Started Installing IR-extenderInstalling Batteries Battery IndicatorBattery Icon Battery Tips and PrecautionsPlease read the following instructions carefully Touch Screen PrecautionsAbout the Touch Screen Turning the Touch Screen OnEntering the Setup Menus Using Hard KeysTouch Screen Buttons Entering the Setup Menus Navigating the Setup MenusFallowing illustration shows the setup menu tree Device Menu Setting Up the SRC-3810/3815Follow these steps to create a new device Creating a New DeviceFollow these instructions to edit a device label Re-Labeling DevicesAddr Setting RF Address SRC-3815 Device Menu Deleting Devices Code Menu Manually Selecting the Code Using Pre-Code to Program DevicesSelecting a Code Automatically Before Using the Learning Function Using Code Learning ModeLearning from Another Remote Control Erasing Key Codes Erasing Device Codes All unrecognized codes should be sent to this address Debugging Device CodesCode Menu LCD Layout Using Macros Follow these steps to create a new macro Creating a New MacroPress the DVD play key Follow these steps to delete a macro Deleting a MacroFollow these steps to view the steps of a macro Viewing a MacroFollow these steps to create a new Quick CH Setting Quick CHsSetting a Quick CH Menu, press and to scroll through the menu optionsFollow these steps to delete a Quick CH Deleting a Quick CHRelabeling a Quick CH Using the Transmission Feature Miscellaneous Menus Setting the Date and Time Setting the Backlight On Time Setting the Power Down TimeSetting the Beep Signal Checking the Version Number Resetting the SRC-3810/3815 to Factory DefaultsPage Selecting a Device to Control Controlling DevicesViewing the Macro Key Alternating Touch Screen PagesUsing the Quick CH Buttons Controlling Devices Using the AUX KeyModel SRC-3810/3815 Appendix a SpecificationsUSB cable Appendix B AccessoriesAdditional RF IR-extender SEL-6000 for SRC-3815 IR Blaster Cable SRC-IR for SRC-3815Troubleshooting Tables Appendix C TroubleshootingRF mode Troubleshooting Tables