Sunwave Tech SRC-3810, 3815 manual Battery Tips and Precautions, Battery Icon

Page 12

SRC-38 SERIES User’s Manual

Battery	Battery half	Battery
full	full	low

Figure 2: The Battery Icon

When the batteries are almost depleted, the battery low icon appears.

When the battery low icon appears, you are not allowed to enter setup mode.

Battery Tips and Precautions

•Immediately replace the batteries when the battery low icon appears.

•The SRC-3810/3815 will not lose programmed data when batteries are replaced, but will reset the time.

•Always use fresh batteries. Alkaline batteries are recommended. Do not mix different types of batteries.

•Be sure that the positive (+) and negative (–) polarities of the batteries match the diagram shown in the compartment.

•Do not expose the batteries to excessive heat or flame.

•Keep batteries out of the reach of children.

•Weak batteries reduce the effective distance of the unit.

•To reduce danger of leakage and damage, remove used batteries when used longer than two years.

6

Image 12

Contents SRC-3810/3815 031021Page Preface Table of Contents Iii Page SRC-3810/3815 Features Following list identifies the SRC-3810/3815’s key featuresIntroducing the SRC-3810/3815 Unpacking the SRC-3810/3815 Identifying Components Backlight press this button to turn on the LCD backlightFor SRC-3815 Remote Control Installing IR-extender Installing BatteriesBattery Indicator Getting StartedBattery Tips and Precautions Battery IconTouch Screen Precautions About the Touch ScreenTurning the Touch Screen On Please read the following instructions carefullyUsing Hard Keys Entering the Setup MenusTouch Screen Buttons Navigating the Setup Menus Entering the Setup MenusFallowing illustration shows the setup menu tree Setting Up the SRC-3810/3815 Device MenuCreating a New Device Follow these steps to create a new deviceRe-Labeling Devices Follow these instructions to edit a device labelAddr Setting RF Address SRC-3815 Device Menu Deleting Devices Code Menu Using Pre-Code to Program Devices Manually Selecting the CodeSelecting a Code Automatically Using Code Learning Mode Before Using the Learning FunctionLearning from Another Remote Control Erasing Key Codes Erasing Device Codes Debugging Device Codes All unrecognized codes should be sent to this addressCode Menu LCD Layout Using Macros Creating a New Macro Follow these steps to create a new macroPress the DVD play key Deleting a Macro Follow these steps to delete a macroViewing a Macro Follow these steps to view the steps of a macroSetting Quick CHs Setting a Quick CHMenu, press and to scroll through the menu options Follow these steps to create a new Quick CHDeleting a Quick CH Follow these steps to delete a Quick CHRelabeling a Quick CH Using the Transmission Feature Miscellaneous Menus Setting the Date and Time Setting the Power Down Time Setting the Backlight On TimeSetting the Beep Signal Resetting the SRC-3810/3815 to Factory Defaults Checking the Version NumberPage Controlling Devices Selecting a Device to ControlAlternating Touch Screen Pages Viewing the Macro KeyUsing the Quick CH Buttons Using the AUX Key Controlling DevicesAppendix a Specifications Model SRC-3810/3815Appendix B Accessories USB cableIR Blaster Cable SRC-IR for SRC-3815 Additional RF IR-extender SEL-6000 for SRC-3815Appendix C Troubleshooting Troubleshooting TablesRF mode Troubleshooting Tables