Sunwave Tech SRC-3810, 3815 manual RF mode

SRC-38 SERIES User’s Manual

The SRC-3810/3815	In RF mode:
doesn’t operate a	Make sure the SEL-6000 IR-extender is
device.	aimed at desired equipment.
	Make sure RF Address on IR-extender
	matches settings in SRC-3815.
You cannot operate	Make sure that your SRC-3810/3815 has
a device even after	correctly “learned” device's remote
teaching the device	control code. (page 21).
using the learning	Delete the device data from the SRC-
function.	3810/3815 and carry out the learning
	function again (page 20).
	Make sure you did not program more
	than one remote for a given device.
You see “ERROR”	Make sure you hold the other remote’s
display on the LCD	button down for about 2 seconds.
during the learning	Make sure you did not program more
procedure.	than one remote for a given device.
	Make sure the two remotes are not too
	close or too far apart and are aiming
	directly at each other - keep apart
	between 2~4 inches (5~10cm).
You see “ERROR”	The button that you pressed has not
display during	been taught.
operation.	Learn the button using the learning
	procedure (page 20).
Your VCR will not	As a safety feature on SRC-3810/3815,
record.	you must press the REC key for 2 seconds.
Problems changing	If your original remote requires the ENTER
channels.	key to be pressed after a channel is
	selected, press the ENTER key to select
	the channel.

50