Sunwave Tech 3815, SRC-3810 manual Learning from Another Remote Control

Code Menu

Learning from Another Remote Control

Before using learning mode, set both remotes on a flat surface so that the device’s remote control IR is pointed at the SRC-3810/3815’s learning eye, which is located at the bottom of the unit.

1.Press or to select Learn.

2.Press .

3.Point the target device's remote control’s infrared eye at the SRC- 3810/3815 learning eye located at the bottom of the unit (see Figure 1: Front View, Page3) and keep apart between 2~4 inches (5~10cm).

4.Press the button corresponding to the target device.

The SRC-3810/3815 Touch Screen sequentially displays screens corresponding to first the hard keys, then page one of the soft keys, and finally page two of the soft keys. The blinking rectangle denotes the key being learned.

5.Press the corresponding button of the target device's remote control.

The SRC-3810/3815 screen displays an OK message if the code was successfully learned or an ERROR message if the code was not learned.

Press to toggle between hard and soft key displays.

Note: When the remote has learned the last button on the page, the next page is automatically displayed.

6.Press to exit learning mode.

21