Crisp Solutions manual Before Using the Learning Function, Operating Ucommand UC-515

Page 17

Chapter 3

OPERATING UCOMMAND UC-515

This chapter shows you how to set up UCommand, how to automatically configure devices, and how to use advanced features such as the macros.

Before Using the Learning Function

Before you start configuring your remote control using the learning function, please heed the following:

You can map multiple devices to the same device layer. This can be very useful; for example, if you wish to control the TV’s volume using your amplifier, without having to change between the two device screens. In this case, you learn the regular TV functions from the TV but the volume functions from the amplifier remote. In some rare cases, if you assign too many different remotes to the same device layer, this might fail, although no corruption of data or other damage will occur.

If you are going to configure a different remote control for a UCommand device button after you have previously configured the device button for a different remote control, first delete all the commands for the device button. Refer to Using the Delete Function on page 16.

When using the learning function, you must press each button within 120 seconds. Otherwise, UCommand will exit learning mode and return to normal operation mode.

Image 17 Crisp Solutions manual Before Using the Learning Function, Operating Ucommand UC-515
Contents With Touchscreen & Learning Function User’s GuideEdition Radio Frequency Interference Table of Contents Appendix a Page Chapter Unpacking UCommandIntroduction UCommand UC-515 FeaturesLCD Identifying ComponentsIntroduction Getting Started Power SupplyPower Supply Tips and Precautions Battery Low IconLCD Touch Screen PrecautionsTouch Screen Buttons Device buttons Getting Started Operating Ucommand UC-515 Before Using the Learning FunctionUsing the learning eye Using the Learning FunctionUsing the Learning Function Learning icon Blinking icon OK icon Next button to be mapped Delete Device Button Using the Delete FunctionUsing the Delete Function Bank delete Delete all devices Changing the LCD Layout Changing the LCD Layout Macro Function Changing the AUX Device LayoutMacro Function Operating UCommand UC-515 Macro Example Operating UCommand UC-515 Macro Running the Macro Adjusting the LCD Backlight Operating UCommand UC-515 Current Turning off the beep signal Turning Off the Beep SignalRecalling the Original LCD Layout Recalling the original LCD panel configurationOperating UCommand UC-515 Appendix a ALL Available Icons for the Ucommand Appendix B UCommand User’s Guide UCommand UC-515