Crisp Solutions UC-515 manual UCommand User’s Guide

UCommand User’s Guide

You see an	∙ Try the learning procedure again (page
“error” display	12).
during the	∙ The source remote uses an uncommon
learning
	code, which may not be learnable by the
procedure.
	UCommand.
	∙ The source remote uses a frequency lower
	than 10kHz or higher than 150 KHz
You see an	∙ The button that you pressed has not been
“error” display	configured. Configure the button again,
during	using the learning procedure (page 12).
operation.
The RECORD	∙ A feature of UCommand prevents the
button does not	record function of your Tape or VCR from
work	starting unintentionally. Hold the RECORD
	button for about 2 seconds for the
	command to be sent to the VCR.
Problems	∙ Some remotes return a confirmation signal
learning from 2-	from the device, which can confuse the
way remotes	learning capability. Turn off the device
	while programming, or go to another room.
	Alternately, move UCommand out of the
	line-of-sight of the device immediately
	after programming a button.
The LCD screen	∙ UCommand is preset at the factory to
turns off.	automatically switch the LCD off after 20
	minutes if left unused. Just tap the LCD
	screen to turn UCommand back on again.

Our Support Website is constantly updated. Open your browser to www.crispsolutions.com.

38