Crisp Solutions UC-515 manual Using the Learning Function

Page 19

UCommand User’s Guide

After you have lined up your remote control with UCommand’s learning eye, you can use the learning function. Follow these instructions:

Press the Learn button for three seconds.

1

1

You will hear a beep, and then you will see the setup mode enable screen to the right.

Note: This screen prevents you from accidentally modifying UCommand.

Press each number button in any order until it disappears.

Using the Learning Function

13

Image 19
Contents With Touchscreen & Learning Function User’s GuideEdition Radio Frequency Interference Table of Contents Appendix a Page Chapter Unpacking UCommandIntroduction UCommand UC-515 FeaturesLCD Identifying ComponentsIntroduction Getting Started Power SupplyPower Supply Tips and Precautions Battery Low IconLCD Touch Screen PrecautionsTouch Screen Buttons Device buttons Getting Started Operating Ucommand UC-515 Before Using the Learning FunctionUsing the learning eye Using the Learning FunctionUsing the Learning Function Learning icon Blinking icon OK icon Next button to be mapped Delete Device Button Using the Delete FunctionUsing the Delete Function Bank delete Delete all devices Changing the LCD Layout Changing the LCD Layout Macro Function Changing the AUX Device LayoutMacro Function Operating UCommand UC-515 Macro Example Operating UCommand UC-515 Macro Running the Macro Adjusting the LCD Backlight Operating UCommand UC-515 Current Turning off the beep signal Turning Off the Beep SignalRecalling the Original LCD Layout Recalling the original LCD panel configurationOperating UCommand UC-515 Appendix a ALL Available Icons for the Ucommand Appendix B UCommand User’s Guide UCommand UC-515