4CH
Carefully following the steps to ensure correct installation.
*** Note: Please set one HDD to “Master Mode” or “Single Mode” ***
•Step 1 Connect the connector with the HDD (refer to Picture 1).
•Step 2 Put HDD into the HDD cartridge. Please notice the bottom side is power side as chart shows (refer to Picture 2).
•Step 3 Screw the HDD to the cartridge. Before you screw the HDD, please be aware that you must to level pin 1 of the HDD at pin 1 mark, because the screw hole is different from different HDD brands. Then screw the HDD correctly (refer to Picture 3 and 4). You must precisely align the hard disk to the pin connection to ensure correct installation.
•Step 4 Reverse the HDD and put it into DVR (refer to Picture 5 and 6).
•Step 5 Connect the HDD with DVR (refer to Picture 7).
•Step 6 Lock the cabinet by turning the key clockwise (refer to Picture 8).
A ( locked )
B ( unlocked )
Note : If you do not lock the cabinet, the DVR system will not function properly.
•Step 7 Close the cap (refer to Picture 9).
50