Mitsubishi Electronics WD-52528, WD-62527 Device Setup Screen, TV Guide On Screen System Setup

NetCommand® Initial Setup, continued

Device Setup Screen

Figure 3

If the devices connected to the TV are already in NetCommand memory, you can quickly select them at

this screen. Press ADJUST or	to move to each
device type. Press ADJUST	or to select the
manufacturer. Select “Other” if	the manufacturer is

not listed. Later, you can use the Change setting in the Edit NetCommand menu to learn the remote control signals for this device. Select “None” for device types that are not connected.

For the A/V Receiver, if the manufacturer is not listed, you cannot select “Other”. Instead, select “None”. Later, you can use the “Add” feature in the NetCommand menu to have the TV add and learn the remote control signals for this device.

If you have a camcorder connected, check the Camcorder box. NetCommand will not be able to control it, but will reserve the front input to use with the camcorder. After completing your choices, select Next> and press ENTER.

Figure 3. Device Setup screen

Note: If you selected “Other” for any of the device names, you can direct the TV to “Learn” the connected device by following the Edit NetCommand instructions. For many device types, non-listed models will operate in the same way as the listed models and you can still use the pre- loaded setting.

TV Guide On Screen® System Setup

Figure 4

The TV Guide On Screen option allows you to select whether you want to enable the TV Guide On Screen system and, if so, which devices you want to include. In order to get the correct listings for your area, you will need to enter your five-digit ZIP code.

You can select one over-the-air source and one cable source for TV Guide On Screen. If, however, you have multiple cable sources, the channel-number assignments may not match up correctly. See the table below for the preferred connection combinations.

If One Source Is:	The Other Source Can Be:
Ant-1 over-the-air	• Cable box (on any input)
reception	•	Ant-2 channels memorized
		via cable
Ant-2 over-the-air	• Cable box (on any input)
reception	•	CableCARD™ on Ant-1
	• Ant-1 channels memorized
		via cable

For detailed information on using the TV Guide On Screen system, please see the separate TV Guide On Screen Interactive Program Guide User’s Manual.

Figure 4. TV Guide On Screen

Note:

•Inputs to TV Guide On Screen can include:

-Only one over-the-air source

-Only one cable source

•If your cable box is connected using HDMI or IEEE‑1394, we recommend you also connect an antenna.

•If your cable box is connected to Component 1 or 2, you should make sure the box is set to send analog channels as 480i. If this is not possible, add an antenna.

Chapter 3. NetCommand Setup and Editing 41