Mitsubishi Electronics WD-62527, WD-62528, WD-52528 manual Review Screen, Review screen

NetCommand® Initial Setup, continued

Review Screen

Figure 5

After you have made your device choices the Review Screen will display. It is important to review the settings to ensure that they are correct. If necessary, you can use <Back to return to the Device Setup screen to make changes.

Finish Screen

Figure 6

To complete the NetCommand setup, select Finish from the Finish screen.

If you wish to change any of the pre- configured inputs or names for the devices, or add devices not in the pre-configured setup, select Edit to display Edit NetCommand menu.

If your A/V receiver was not listed, select Edit to add the AVR and then assign all devices to new AVR inputs.

Figure 5. Review screen

Note: The Review screen lists the TV input and A/V receiver input used with each device. You must correctly identify the inputs you used when you connected the devices. If you have not connected your devices, write down these inputs as a guide. If you cannot use these inputs, or if you would like to change the name of a device, use the instructions in Edit NetCommand to make necessary changes.

Note: If you select Next> on the Review screen, all selections made are finalized.

On the Review screen, adding or deleting check marks will turn the adjacent devices or inputs On or Off. 1394 device names only appear on the Review screen when the devices are connected to the TV.

Figure 6. Finish screen

It is still necessary to memorize the available channels for Antenna-1 (and Antenna-2, if used). You may do that by going to the TV Main menu and selecting Antenna. Instructions to memorize channels are found in the Antenna menu section.

42 Chapter 3. NetCommand Setup and Editing