Edit NetCommand® Add Devices, continued
[Device] Screen
Figure 16
If you selected “None”, during initial setup, then you can add a device. If you have added a new device, use this screen to start learning.
Our examples show the choices for adding a VCR, however, the same type of screens will appear for any DBS (Direct Broadcast Satellite), DVD player or Cable Box.
•Select “Other”, skip Learn and select Next>. This will allow the device to appear and will allow NetCommand to switch inputs to use this device. However, NetCommand will not be able to control this device. Later you may use the “Change” option in the Setup menu to learn the remote control signals.
After selecting Next>, the screens that follow are: the Name Screen (Figure 19), Connection screen (Figure 20) and specialized device screens (Figures
[Device] Learn Screen
Figure 17
Shown only if “Learn” was selected
1. Press ADJUST 
, 
, 
or 
to select the check box
f o r each function to be learned.
2. Press ENTER and the function name will begin to flash to confirm the
Figure 16. [Device] screen
Choose ONE of these options:
•Select a recognized manufacturer. The model number optimized for NetCommand will display at the bottom of the screen. If a number follows the manufacturer’s name, (example: Mitsubishi 1), this indicates additional models are optimized for that manufacturer. For many device types,
After selecting Next>, the screens that follow are: the Name Screen (Figure 19), Connection screen (Figure
20)and specialized device screens (Figures
•Select “Other”, then highlight “Learn” and press ENTER. This will allow you to have NetCommand learn the remote control signals of this new device.
After selecting “Learn” and pressing ENTER, the screens that follow are: [Device] Learn screen (Figure 17), [Device] Advanced Learn screen (Figure 18), Name screen (Figure 19), Connection screen, (Figure
20)and specialized device screens (Figures
3.Press the button on the device’s remote control that corresponds to the selected function. A check mark will appear and the function name will stop flashing. This confirms the signal learned status.
4.To test the learned command, press the ENTER button on the TV remote while the learned function is still highlighted. The device should perform the selected function. The device needs to be turned on and the IR emitters properly placed for the test to be successful (see page 31 for IR emitter placement).
5.Repeat for each function to be learned.
6.To erase a learned function, highlight the check box for that function and press CANCEL.
7.When the function signals have been learned, press
ADJUST 
to select Next> and move to the [Device] Advanced Learn screen.
NOTE: When learning the device’s remote control signals, point the device’s remote control at the TV screen.
Hint: If the device’s remote control uses a single button for both Power On and Power Off, don’t learn the Power Off function.
Chapter 3. NetCommand Setup and Editing 47