NetCommand® Initial Setup
IMPORTANT
You may use your TV without setting up NetCommand. You may also set up NetCommand at a later time by choosing NetCommand from the Main menu, then selecting Initial.
Welcome Screen
Figure 1
When you first turn on your TV, the Welcome screen displays and asks you to select either English or Spanish as the language for the
Figure 1. Welcome screen
NetCommand (Information) Screen
Figure 2
The NetCommand (Information) Screen describes how to start or delay the initial NetCommand Setup. This screen displays automatically the first time you power On your new TV, after the Welcome screen.
Figure 2. Information screen
If the NetCommand Setup is cancelled before it’s completed, you can restart the NetCommand setup by:
1.A press of TV MENU on the remote control to display the TV Main menu.
2.Select NetCommand. The available options will be: Add, Review or Initial. Change and Delete will be grayed out.
3.Press ADJUST 
, 
, 
or 
to select Initial.
4.Press ENTER. The Device Setup screen displays.
Device Setup Screen
Figure 3
If the devices connected to the TV are already in NetCommand memory, you can quickly select them at this screen. Press ADJUST 
or 
to move to each device type. Press ADJUST 
or 
to select the manufacturer. Select “Other” if the manufacturer is not listed. Later, you can use the Change setting in the Edit NetCommand option of the Setup menu to learn the remote control signals for this device. Select “None” for device types that are not connected.
For the A/V Receiver, if the manufacturer is not listed, you cannot select “Other”. Instead, select “None”. Later, you can use the “Add” feature in the NetCommand menu to have the TV add and learn the remote control signals for this device.
If you have a camcorder connected, check the Camcorder box. NetCommand will not be able to control it, but will reserve the front input to use with the camcorder. After completing your choices, select Next> and press ENTER.
Figure 3. Device Setup screen
Note: If you selected “Other” for any of the device names, this chapter describes how the TV can “Learn” the connected device by following the Edit NetCommand instructions. Most IR remote control signal formats can be learned by NetCommand.
33