Adjusting the angle of projection

Screen on a flat wall with a 90 degree angle to the floor by adjusting two foot adjustments on the bottom of the projector. If the angle cannot be corrected by them, adjust the height and angle of screen.

Getting ready for projection

1.Connect the power cord provided to this projector with the power jack of the projector.

2.Connect the power cord to the wall outlet.

screen

foot adjustment

Plug in the provided power cord directly.

ground terminal

3.	Take off the lens cap.
4.	Do not look directly into the lens when projector is

ENGLISH

1.Lift the projector to the right angle.

2.Press the release button for angle adjustment to take the adjustment feet out of the projector.

3.Release the button and keep your hands away from the projector.

4.Turn the both feet to right or left to adjust for proper angle.

After using the projection,

5.Press the release button to take the projector down slowly with holding it.

Important:

The image becomes trapezoid shape when the screen or project is not level. Use KEYSTONE in ENHANCED menu to adjust, however, the circumference of the im- age may not be focused. See page 20.

•Screen on a flat wall with a 90˚ angle to the floor.

•Align projector to produce a full screen display as illustrated on page 10.

•Distance from projector to screen must be compatible with screen size chart on page 10. Note distance from screen chart.

•If image is not square on screen, try adjusting the front feet of the projector for proper angle.

“ON”.

Warning:

•The lens cap is for protecting the lens. If you leave the power on with the cap on, the cap may be warped. Please remove the lens cap when you turn the power on.

•A three-pin grounding type power plug is used with the projector. Do not remove the grounding pin on the power plug. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet.

•The supplied power cord is used for 120V only. Never connect to any outlet or power supply having a dif- ferent voltage or frequency. If you connect to the power supply having a different voltage, please use the appropriate power cord.

•Do not place an object on the power cord and keep the projector away from heat source to avoid break- ing the power cord. A broken of power cord can cause fire or electric shock.

•Do not revise or alter the power cord otherwise it may cause fire or electric shock.

Contact your dealer if the cord is broken.

Caution:

•Plug in firmly and unplug by holding the plug, not by pulling the cable out.

•Do not plug in or out with wet hands. It may cause an electric shock.