Overview of the projector
ENGLISH
lamp lid
Caution:
Do not replace the lamp right after using the projector. The lamp is very hot. Switch the projector to
exhaust slits
handle
Hold here to carry this projector.
remote control sensor (Front / Rear)
release button
Press to adjust the angle of projection. See page 11.
power indicator
When the main power switch is on in
lamp indicator
This informs you of the status of the light source lamp and its service life. When the projector lamp is lit, the indicator lights up in green. When operation time of the light source lamp has exceeded 1,000 hours, the indicator will flash alternately between red and green (while the lamp is in use). When the lamp is exhausted, the indicator will show red only. When the lamp is used up to 1,300 hours, the projector automatically shuts off. See pages 40 and 44.
temperature indicator
This informs you of the thermal condition inside the projector. When the inside temperature is extremely high, the power automatically shuts off while the indicator blinks red. See page 44.
PC card indicator
When the PC card is inserted, these indicators light up. See page 27.
LAMP TEMP | CARD 1 | CARD 2 |
RGB VIDEO CARD | MENU | FINE |
FOCUS AUTO /ZOOM POSITION
ENTER
auto position
Use to adjust the position of Personal computer image. See page 16.
input source
(RGB, VIDEO, CARD)
Use to select the input source you wish to watch.
menu
Use to project menu display.
focus / zoom
Use to change the mode of the adjust buttons, focus or zoom etc. See the table as shown below.
ª, º
Use to make FOCUS or ZOOM adjustments etc. See the table as shown below.
fine ( | ª | , | ª | ) |
Use to make FINE adjustment etc. See the table as shown below.
power
Use to turn the projector on or off when MAIN POWER is on. To turn the projector off, press this button twice.
Important:
When the lamp indicator lights up in green, the power switch cannot be used to switch “ON” and “OFF.” Begin operation only after the indicator has stopped blinking.
FINE, º, ª, FOCUS/ZOOM and AUTO POSITION buttons
The operations of these buttons vary as follows depending on the modes selected:
| FINE ( | ) | FINE ( ) | º | ª | FOCUS / ZOOM | AUTO POSITION | |
|
|
|
|
|
|
|
| |
Normal | Adjust FINE | Adjust FINE(+) | Adjust FOCUS or | Adjust FOCUS or | FOCUS or ZOOM | Adjust position | ||
ZOOM | ZOOM (+) | setting | when incorrect | |||||
|
|
|
|
|
|
| ||
On Menu | Select the setting | Select the setting | Set the setting | Set the setting | Enter the layer | – | ||
item (Left) | item (Right) | item | item | setting | ||||
| ||||||||
|
|
|
|
|
|
| ||
On PC | Select previous | Select next | Select | Select | Select the | Select the | ||
card Menu | image (Left) | image (Right) | INDEX or FILE | INDEX or FILE | group | group (+) | ||
|
|
|
|
|
|
|
| |
6