Replacement of a light source lamp

The light source lamp is designed to project the image on the LCD panel. When the light source lamp no longer functions, replace it with a new one to ensure optimum performance.

Caution:

•	Do not remove the light source lamp from inside of
	this equipment immediately after using the projec-
	tor, you may get burned because of the high tem-
	perature of the light source lamp.
•	When you replace the light source lamp, press the

3.Set Lamp exchanging metal into the projector.

1)Insert metal fittings for lamp replacement in the following positions: on the front face of the lamp (2 positions), between the lamp, and on the bottom edges (4 positions).

2)Align screw holes (c) with node (d).

3)Fasten the piece into place using the two screws included (b, b’).

(d)

ENGLISH

power button to power off, then wait for 120 sec-

onds in stand-by mode to cool down the lamp and

LCD panels. Turn off the main switch, unplug the

power code from the outlet and wait one hour so

that the lamp is cool to the touch.

(c)

(e)

(b)

(b')

Lamp exchange metal

• Do not remove the light source lamp except for re-

placement. Careless treatment can cause injury or

fire.

• Do not touch the lamp directly. It may be broken

and may cause you to injure or burn yourself.

• Be sure not to drop the lamp lid screw into the pro-

jector. Also be sure also not to insert metal or any

flammable objects, it may cause fire or an electric

shock. If any objects are inserted, please unplug and

contact your dealer.

• Install the lamp securely, failure to do so it may

cause a fire.

1. Loosen the screw of	Loosen here
the lamp lid on the
top cover using a
screwdriver (+) , and
remove the lid.

•Remove the lamp cover in the direc-

tion of the arrow as indicated.

Important:

Be careful not to damage the electric wire connected to this equipment.

	Hooks
Lamp	(x 6)

4.Loosen the lamp fixing screw (e) using a screwdriver (+), and remove it.

5.Hold onto the projector

by the handle as you pull	Handle
out the lamp.
For the lamp you have
removed, do not spill liq-
uid on it, place it near
flammable objects or
where children can touch
it. Otherwise, it will cause in-
jury or fire.

6.Insert the new lamp securely into the projector body in the right direction.

7.Tight up the screws (e) which

have been removed in 4 using a screwdriver (+).

2. Loosen a screw (a) of fix-	(a)	Fixing
ing metal using a screw-	(a)	Fixing
ing metal using a screw-		metal
driver (+), and remove		metal
driver (+), and remove
them.
Do not lose the fixing		(e)
metal and screws.

8.Loosen the two screws (f), (f') of lamp exchanging metal using a screwdriver, and re- move them with the metal.

9.Remove the holes from the lamp replacement metal fittings (c) from the node

(d).

(f)(f')

(e)

10. Insert the fixed metal pieces	(a)
from step 2 into the screw
holes (f) and (f ’), and use one
screw (a) to hold the piece in
place.