Eiki EIP-3500 Switching the Input Mode, Adjusting the Volume, Input buttons, Volume buttons

Switching the INPUT Mode

Select the appropriate input mode for the con- nected equipment.

Press , , or on the re- mote control to select the input mode.

•When pressing ' or " on the projector, input mode switches in order of :

INPUT 1 INPUT 2 INPUT 3 INPUT 4

Note

•When no signal is received, “NO SIGNAL” will be displayed. When a signal that the projector is not preset to receive is received, “NOT REG.” will be displayed.

•The INPUT mode is not displayed when “OSD Display” of the “Options1” menu is set to “” (OFF). (See page 51.)

About the INPUT mode

INPUT 1/	Used for projecting images from
INPUT 2	equipment that sends RGB sig-
(RGB/	nals or component signals con-
Component)	nected to the RGB input terminal.
INPUT 3	Used for projecting images
(Video)	from equipment connected to
	the VIDEO input terminal.
INPUT 4	Used for projecting images
(S-Video)	from equipment connected to
	the S-VIDEO input terminal.

Adjusting the Volume

Press \ /on the projector or VOL / on the remote control to ad- just the volume.

Note

•Pressing or \ will lower the volume. Pressing or will raise the volume.

/ / /

INPUT buttons

"On-screen Display of INPUT Mode (Example)

	➝
INPUT 1/2 mode
Using RGB

Using

Component

INPUT 3 mode	➝
	➝
Using Video
INPUT 4 mode	➝
	➝
Using S-Video
	➝

Volume buttons

"On-screen Display

33