Eiki EIP-3500 System Lock Function, Select System Lock on the Op Tions1 menu, then press

Using the “Options1” Menu

System Lock Function

This function prevents unauthorized use of the pro- jector. Once this function is activated, users must enter the correct keycode each time the projector is turned on. We suggest you record the keycode in a safe place where only authorized users have access.

Info

•If you lose or forget your keycode, contact your nearest EIKI Authorized Projector Dealer or Ser- vice Center. Even if the product warranty is valid, the keycode reset will incur a charge.

Menu operation Page 42

Example: “Options1” screen menu for INPUT 1 (RGB) mode

Setting the keycode

1Select “System Lock” on the “Op-

tions1” menu, then press .

•A message is displayed.

•Read this message, and press .

2Press the 4 buttons on the remote control or on the projector to enter the preset keycode in “Old Code”.

•When setting the keycode for the first time,

press " on the projector for four times.

"On-screen Display

Note

•If you input a wrong keycode, the cursor returns to the first point of the “Old Code”.

•The preset keycode is 4 " buttons on the projec- tor. If this keycode is set, the keycode input screen does not appear when turning the power on.

3Press the 4 buttons on the remote control or on the projector to enter the new keycode in “New Code”.

Note

•You cannot use the following buttons for keycode:

•POWER button

•L-CLICK/ENTER button

•R-CLICK/UNDO button

•MENU button

•AUTO FOCUS button

•ZOOM-FOCUS button

•ZOOM buttons

•FOCUS buttons

•System Lock function recognizes each but- ton on the remote control or on the projec- tor as an individual button, even if they share the same button name. If you set the keycode with the buttons on the projector, use only those buttons on the projector. If you set the keycode with the buttons on the remote con- trol, use only those buttons on the remote control.

4 Enter the same keycode in “Reconfirm”.

Note

Not displaying the keycode input screen when turning the projector on

•Press " on the projector for four times in steps 2 and 3 above.

When the System Lock is set

•When System Lock is set, the keycode input screen appears after the power is turned on. When it appears, enter the right keycode to start projection. Failure to enter the keycode will cause images not to be projected even when signals are entered to the projector.

54