BenQ PB6240 Bottom side, Connector panel, Front adjuster foot Lamp cover Rear adjuster foot

Page 12

Bottom side

Front adjuster foot

Lamp cover

Rear adjuster foot	Rear adjuster foot

Connector panel

Refer to page 12 for more information on making connections to various equipment.

IR remote sensor

RGB signal output socket & RS232 control port

RGB signal input (PC/ YPbPr/ YCbCr) socket

USB socket

Audio socket

S-Video socket

Video socket

AC power cord inlet

8 Introduction

Image 12

Contents Welcome Copyright DisclaimerTable of contents Projector specifications Iv Table of contentsImportant safety instructions But could fail if power cuts or surgesImportant safety instructions Safety Instructions Locations near fire alarms Locations with an ambient temperatureUsing the unit when it is not fully Bedding or any other soft surfaceSafety Instructions Projector features IntroductionIntroduction Shipping contents Optional accessories Projector exterior viewFront / upper side Rear sideConnector panel Front adjuster foot Lamp cover Rear adjuster footBottom side Controls and functions External control panelYour Microsoft PowerPoint Sequentially select the input signalRemote Ccontrol BackwardsRemote control effective range Installing or replacing the remote control batteryPositioning your projector Choosing a locationObtaining a preferred projected image size Focus ring Zoom ring Positioning your projectorScreen size chart 43 aspect ratio Screen size chart 169 aspect ratioConnecting a computer Connecting Component Video devicesConnection VGA cable Audio cable USB cableConnecting Video or S-Video devices Connecting display devicesVideo or Video devices Utilizing the password function To set a passwordOperation Start upIf you forget the password To enter the password recall procedureTo change the password Adjusting the image Adjusting the heightAuto-adjusting the image Fine-tuning the image size and claritySelecting a picture mode Presentation default SRGB/Photo Gaming VideoCorrecting keystone Switiching input signal Hiding the imageSlide operation Freezing the imageDisconnect the power cord from the wall socket ShutdownMenu operation Menu systemUsing the menus Picture menu ApplicationMode Color TempBrightness ContrastColor TintPro-Picture menu Setting menu Advance menu Information menu Maintenance Care of the projectorLamp information Replacing the lampDo not turn the power on with the lamp cover removed Temperature information IndicatorsProjector needs 110 seconds to cool down. Or Please contact your dealer for assistanceFor assistance Service information Accessories included in the standard packageOptional accessories not included in the standard package Ordering parts or getting informationTroubleshooting Plug the power cord into the AC inlet onMake sure that it is switched on Specifications Projector specificationsTiming chart Supported timing for PC inputSupported timing for Component-YPbPrinput Supported timing for Video and S-Video inputsDimensions Unit mm SpecificationsWarranty Limited WarrantyWarranty Regulation Statements FCC statementEEC statement MIC statement