BenQ PB6240 user manual Regulation Statements, FCC statement, EEC statement, MIC statement

Page 46

Regulation Statements

FCC statement

CLASS B: This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter- ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the distance between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

EEC statement

This machine was tested against the 89/336/EEC (European Economic Community) for EMC (Electronic Magnetic Compatibility) and fulfills these requirements.

MIC statement

B class equipment (Household purpose info/telecommunications equipment)

As this equipment has undergone EMC registration for household purpose, this product can be used in any area including residential area.

42 Regulation Statements

Image 46
Contents Welcome Copyright DisclaimerTable of contents Projector specifications Iv Table of contentsBut could fail if power cuts or surges Important safety instructionsImportant safety instructions Safety Instructions Using the unit when it is not fully Locations near fire alarmsLocations with an ambient temperature Bedding or any other soft surfaceSafety Instructions Introduction Projector featuresIntroduction Shipping contents Front / upper side Optional accessoriesProjector exterior view Rear sideFront adjuster foot Lamp cover Rear adjuster foot Connector panelBottom side Controls and functions External control panelRemote Ccontrol Your Microsoft PowerPointSequentially select the input signal BackwardsRemote control effective range Installing or replacing the remote control batteryPositioning your projector Choosing a locationObtaining a preferred projected image size Focus ring Zoom ring Positioning your projectorScreen size chart 43 aspect ratio Screen size chart 169 aspect ratioConnection Connecting a computerConnecting Component Video devices VGA cable Audio cable USB cableConnecting display devices Connecting Video or S-Video devicesVideo or Video devices Operation Utilizing the password functionTo set a password Start upTo enter the password recall procedure If you forget the passwordTo change the password Auto-adjusting the image Adjusting the imageAdjusting the height Fine-tuning the image size and clarityPresentation default SRGB/Photo Gaming Video Selecting a picture modeCorrecting keystone Slide operation Switiching input signalHiding the image Freezing the imageDisconnect the power cord from the wall socket ShutdownMenu operation Menu systemUsing the menus Mode Picture menuApplication Color TempColor BrightnessContrast TintPro-Picture menu Setting menu Advance menu Information menu Maintenance Care of the projectorLamp information Replacing the lampDo not turn the power on with the lamp cover removed Temperature information IndicatorsPlease contact your dealer for assistance Projector needs 110 seconds to cool down. OrFor assistance Optional accessories not included in the standard package Service informationAccessories included in the standard package Ordering parts or getting informationPlug the power cord into the AC inlet on TroubleshootingMake sure that it is switched on Specifications Projector specificationsSupported timing for Component-YPbPrinput Timing chartSupported timing for PC input Supported timing for Video and S-Video inputsDimensions Unit mm SpecificationsLimited Warranty WarrantyWarranty EEC statement Regulation StatementsFCC statement MIC statement