BenQ PB6240 user manual Connecting Video or S-Video devices, Connecting display devices

Page 20

The following standards are supported in the digital TV function:

•	480i	•	480p
•	576i	•	576p
•	720p (50/ 60 Hz)	•	1080i (50/ 60 Hz)

Connecting Video or S-Video devices

S-Video or Video devices

Audio cable	D-
	SUB
	SUB/COMPD- IN

AUDIO

S-VIDEO VIDEO

AC-

Video cable

S-Video cable

If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the video source is turned on and operating correctly. Also check that the signal cables have been connected correctly.

Connecting display devices

If you want to monitor your presentation close-up on a monitor as well as on the screen, you can connect the RGB signal output port on the projector to an external monitor with a VGA cable.

VGA cable

D SUB-

OUT

SUB/COMPD-

AUDIO

S-VIDEO VIDEO

AC-INLET

16 Connection

Image 20

Contents Welcome Copyright DisclaimerTable of contents Projector specifications Iv Table of contentsImportant safety instructions Important safety instructionsBut could fail if power cuts or surges Safety Instructions Locations near fire alarms Locations with an ambient temperatureUsing the unit when it is not fully Bedding or any other soft surfaceSafety Instructions Introduction Projector featuresIntroduction Shipping contents Optional accessories Projector exterior viewFront / upper side Rear sideBottom side Connector panelFront adjuster foot Lamp cover Rear adjuster foot Controls and functions External control panelYour Microsoft PowerPoint Sequentially select the input signalRemote Ccontrol BackwardsRemote control effective range Installing or replacing the remote control batteryPositioning your projector Choosing a locationObtaining a preferred projected image size Focus ring Zoom ring Positioning your projectorScreen size chart 43 aspect ratio Screen size chart 169 aspect ratioConnecting a computer Connecting Component Video devicesConnection VGA cable Audio cable USB cableVideo or Video devices Connecting Video or S-Video devicesConnecting display devices Utilizing the password function To set a passwordOperation Start upTo change the password If you forget the passwordTo enter the password recall procedure Adjusting the image Adjusting the heightAuto-adjusting the image Fine-tuning the image size and clarityCorrecting keystone Selecting a picture modePresentation default SRGB/Photo Gaming Video Switiching input signal Hiding the imageSlide operation Freezing the imageDisconnect the power cord from the wall socket ShutdownMenu operation Menu systemUsing the menus Picture menu ApplicationMode Color TempBrightness ContrastColor TintPro-Picture menu Setting menu Advance menu Information menu Maintenance Care of the projectorLamp information Replacing the lampDo not turn the power on with the lamp cover removed Temperature information IndicatorsFor assistance Projector needs 110 seconds to cool down. OrPlease contact your dealer for assistance Service information Accessories included in the standard packageOptional accessories not included in the standard package Ordering parts or getting informationMake sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on Specifications Projector specificationsTiming chart Supported timing for PC inputSupported timing for Component-YPbPrinput Supported timing for Video and S-Video inputsDimensions Unit mm SpecificationsWarranty WarrantyLimited Warranty Regulation Statements FCC statementEEC statement MIC statement