BenQ PB6240 user manual Pro-Picture menu

Page 31

2. Pro-Picture menu

Some picture adjustments are available only when certain input ports are in use. Unavailable adjustments are not shown on the screen.

	FUNCTION	DESCRIPTION
	Auto Resize	Makes the best fit of the image to the screen.
	Auto Resize	1. On 2. Off
		1. On 2. Off
	Aspect Ratio	There are two aspect ratio settings.
		1. 4 : 3 (for a standard screen) 2. 16 : 9 ( for a wide screen)
		Adjusts the horizontal position
		Adjusts the horizontal position
		of the projected image.
	H Position

						-30
						-30
		Adjusts the vertical position of
		the projected image.
	V Position

						-30
						-30
		This function allows you to adjust the clock phase
	Phase	to reduce image distortion.
	Phase
	H Size	Adjusts the horizontal width of the image.
	H Size
	Sharpness	Adjusts the image to make it look sharper or softer.
	Sharpness

+30

+30

Operation 27

Image 31

Contents Welcome Disclaimer CopyrightTable of contents Iv Table of contents Projector specificationsBut could fail if power cuts or surges Important safety instructionsImportant safety instructions Safety Instructions Bedding or any other soft surface Locations near fire alarmsLocations with an ambient temperature Using the unit when it is not fullySafety Instructions Introduction Projector featuresIntroduction Shipping contents Rear side Optional accessoriesProjector exterior view Front / upper sideFront adjuster foot Lamp cover Rear adjuster foot Connector panelBottom side External control panel Controls and functionsBackwards Your Microsoft PowerPointSequentially select the input signal Remote CcontrolInstalling or replacing the remote control battery Remote control effective rangeChoosing a location Positioning your projectorFocus ring Zoom ring Positioning your projector Obtaining a preferred projected image sizeScreen size chart 169 aspect ratio Screen size chart 43 aspect ratioVGA cable Audio cable USB cable Connecting a computerConnecting Component Video devices ConnectionConnecting display devices Connecting Video or S-Video devicesVideo or Video devices Start up Utilizing the password functionTo set a password OperationTo enter the password recall procedure If you forget the passwordTo change the password Fine-tuning the image size and clarity Adjusting the imageAdjusting the height Auto-adjusting the imagePresentation default SRGB/Photo Gaming Video Selecting a picture modeCorrecting keystone Freezing the image Switiching input signalHiding the image Slide operationShutdown Disconnect the power cord from the wall socketMenu system Menu operationUsing the menus Color Temp Picture menuApplication ModeTint BrightnessContrast ColorPro-Picture menu Setting menu Advance menu Information menu Care of the projector MaintenanceReplacing the lamp Lamp informationDo not turn the power on with the lamp cover removed Indicators Temperature informationPlease contact your dealer for assistance Projector needs 110 seconds to cool down. OrFor assistance Ordering parts or getting information Service informationAccessories included in the standard package Optional accessories not included in the standard packagePlug the power cord into the AC inlet on TroubleshootingMake sure that it is switched on Projector specifications SpecificationsSupported timing for Video and S-Video inputs Timing chartSupported timing for PC input Supported timing for Component-YPbPrinputUnit mm Specifications DimensionsLimited Warranty WarrantyWarranty MIC statement Regulation StatementsFCC statement EEC statement