BenQ PB6240 Remote control effective range, Installing or replacing the remote control battery

Page 15

Remote control effective range

Infra Red (IR) remote control sensors are located on the front and the back of the projector. The remote control must be held at an angle within 30 degrees of the projector’s IR remote control sensors to function correctly. The distance between the remote control and the sensors should not exceed 6 meters (~ 20 feet).

~ 6 M

Notes on Remote Control Operation:

Make sure that there are no obstacles between the remote control and the IR sensors on the projector that might obstruct the infra-red beam.

Installing or replacing the remote control battery

1.Pull out the battery holder.

2.Insert the new battery in the holder.

3.Push the holder into the remote

control.

Avoid excessive heat and humidity.

There may be danger of an explosion if the battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the battery manufacturer.

Dispose of the used battery according to the manufacturer’s instructions.

Never throw a battery into a fire.

If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent damage to the remote control from possible battery leakage.

Introduction 11

Image 15
Contents Welcome Disclaimer CopyrightTable of contents Iv Table of contents Projector specificationsImportant safety instructions But could fail if power cuts or surgesImportant safety instructions Safety Instructions Bedding or any other soft surface Locations near fire alarmsLocations with an ambient temperature Using the unit when it is not fullySafety Instructions Projector features IntroductionIntroduction Shipping contents Rear side Optional accessoriesProjector exterior view Front / upper sideConnector panel Front adjuster foot Lamp cover Rear adjuster footBottom side External control panel Controls and functionsBackwards Your Microsoft PowerPointSequentially select the input signal Remote CcontrolInstalling or replacing the remote control battery Remote control effective rangeChoosing a location Positioning your projectorFocus ring Zoom ring Positioning your projector Obtaining a preferred projected image sizeScreen size chart 169 aspect ratio Screen size chart 43 aspect ratioVGA cable Audio cable USB cable Connecting a computerConnecting Component Video devices ConnectionConnecting Video or S-Video devices Connecting display devicesVideo or Video devices Start up Utilizing the password functionTo set a password OperationIf you forget the password To enter the password recall procedureTo change the password Fine-tuning the image size and clarity Adjusting the imageAdjusting the height Auto-adjusting the imageSelecting a picture mode Presentation default SRGB/Photo Gaming VideoCorrecting keystone Freezing the image Switiching input signalHiding the image Slide operationShutdown Disconnect the power cord from the wall socketMenu system Menu operationUsing the menus Color Temp Picture menuApplication ModeTint BrightnessContrast ColorPro-Picture menu Setting menu Advance menu Information menu Care of the projector MaintenanceReplacing the lamp Lamp informationDo not turn the power on with the lamp cover removed Indicators Temperature informationProjector needs 110 seconds to cool down. Or Please contact your dealer for assistanceFor assistance Ordering parts or getting information Service informationAccessories included in the standard package Optional accessories not included in the standard packageTroubleshooting Plug the power cord into the AC inlet onMake sure that it is switched on Projector specifications SpecificationsSupported timing for Video and S-Video inputs Timing chartSupported timing for PC input Supported timing for Component-YPbPrinputUnit mm Specifications DimensionsWarranty Limited WarrantyWarranty MIC statement Regulation StatementsFCC statement EEC statement