BenQ PB6240 user manual Limited Warranty

Page 45

Warranty

Limited Warranty

BenQ warrants this product against any defects in material and workmanship, under normal usage and storage.

Proof of purchase date will be required with any warranty claim. In the event this prod- uct is found to be defective within the warranty period, BenQ’s only obligation and your exclusive remedy shall be replacement of any defective parts (labor included). To obtain warranty service, immediately notify the dealer from which you purchased the product of any defects.

Important: The above warranty shall be void if the customer fails to operate the prod- uct in accordance with BenQ’s written instructions, especially the ambient humidity must be in-between 10% and 90%, temperature in-between 0°C and 40°C, altitude lower than 10000 feet, and avoiding to operate the projector in a dusty environment. This war- ranty gives you specific legal rights, and you may have other rights which vary from country to country.

For other information, please refer to BenQ Warranty Information Book.

Warranty 41

Image 45
Contents Welcome Disclaimer CopyrightTable of contents Iv Table of contents Projector specificationsImportant safety instructions But could fail if power cuts or surgesImportant safety instructions Safety Instructions Locations with an ambient temperature Locations near fire alarmsUsing the unit when it is not fully Bedding or any other soft surfaceSafety Instructions Projector features IntroductionIntroduction Shipping contents Projector exterior view Optional accessoriesFront / upper side Rear sideConnector panel Front adjuster foot Lamp cover Rear adjuster footBottom side External control panel Controls and functionsSequentially select the input signal Your Microsoft PowerPointRemote Ccontrol BackwardsInstalling or replacing the remote control battery Remote control effective rangeChoosing a location Positioning your projectorFocus ring Zoom ring Positioning your projector Obtaining a preferred projected image sizeScreen size chart 169 aspect ratio Screen size chart 43 aspect ratioConnecting Component Video devices Connecting a computerConnection VGA cable Audio cable USB cableConnecting Video or S-Video devices Connecting display devicesVideo or Video devices To set a password Utilizing the password functionOperation Start upIf you forget the password To enter the password recall procedureTo change the password Adjusting the height Adjusting the imageAuto-adjusting the image Fine-tuning the image size and claritySelecting a picture mode Presentation default SRGB/Photo Gaming VideoCorrecting keystone Hiding the image Switiching input signalSlide operation Freezing the imageShutdown Disconnect the power cord from the wall socketMenu system Menu operationUsing the menus Application Picture menuMode Color TempContrast BrightnessColor TintPro-Picture menu Setting menu Advance menu Information menu Care of the projector MaintenanceReplacing the lamp Lamp informationDo not turn the power on with the lamp cover removed Indicators Temperature informationProjector needs 110 seconds to cool down. Or Please contact your dealer for assistanceFor assistance Accessories included in the standard package Service informationOptional accessories not included in the standard package Ordering parts or getting informationTroubleshooting Plug the power cord into the AC inlet onMake sure that it is switched on Projector specifications SpecificationsSupported timing for PC input Timing chartSupported timing for Component-YPbPrinput Supported timing for Video and S-Video inputsUnit mm Specifications DimensionsWarranty Limited WarrantyWarranty FCC statement Regulation StatementsEEC statement MIC statement