Guide of
Main Menu
Motorized System
It is used to set the DiSEqC 1.2 motor by Eutelsat specifica- tion. If you wish to use this system, please refer to page 34 for instructions.
Service Search OSD
If you press the EXIT key during the search, service search stops and the searching menu appears.
When you find all the services the following picture appears.
Before saving it, you can select the service you want to delete.
Found services OSD
The picture above shows services that are found after manual search.
You can mark the services that you don’t want to save
using the | i (red) key, these services will turn grey. | To |
unmark a service, select the service and press the | i (red) | |
key on it again. |
| |
Press the | OK key to save, or press the EXIT key to exit | |
without saving.
Then Manual Search menu appears. When you exit all menus, the first service of the found service list is played.
In the bottom of found service picture, network, the informa- tion of transponder and the number of found service that the services belong to are displayed. The deleted service by the
i(red) key is excepted from counting of the number of sevices.
At the bottom of the screen that shows the services found in the search, the information of transponder and the number of found services that the service belongs to are displayed. The
deleted service (using the i (red) key) is not included in this number.
Free means the empty part of all service memory, this is the amount of space available to store other services in the future.
27