Maxtor WDR-516S manual FCC Compliance Statement

Page 2

FCC Compliance Statement

Caution : Any changes or modifications in construction of this device which are not expressly approved the party responsible for compliance could void the user's authority to operate the equipment.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CAUTION

1.Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

2.Disposal of used batteries according to the general recommendations against the environmental pollution.

3.Do not throw the batteries into a fire, and do not heat, short-circuit or attempt to disassemble the batteries.

4.Do not attempt to recharge the batteries.

Image 2
Contents WDR-516S FCC Compliance Statement Important Notice WDR-516S Installation Guide Rev 1.093/11 Connecting External Device with Serial Port Appendix #1 What is WDR-516S? Key featuresSupplied Accessories Description & Function WDR-516S FrontWDR-516S Rear Connecting & Running WDR-516S Connecting cameraConnecting Monitor Connecting AudioSupplying Power Using menu Running OSD menuDialogue Box to Edit a Word Set ID of WDR-516S Setting remote controllerSetting remote control DIP switch Selecting WDR-516S Operable range of remote controller Loading the batteries into remote controllerWDR-516S Configuration Basic Configuration Advanced ConfigurationWDR-516S Installation Guide Rev 1.093/11 WDR-516S Basic Setting Viewing ImageDaylight Saving Setting Date & TimeTime Zone Time Time FormatDate Apply Date/TimeSetting Recording Condition Recording Speed/Quality Configuration StatusChannel Status SpeedipsApply QualityAudio Recording S1 G Connecting and Configuring SensorConnecting Sensor Input Setting Sensor at OSD menu Connecting & Configuring Relay Out Connecting Relay OutConfiguring Relay Out Connecting External Device with Serial Port Connecting Text Input Device ATM / POS / Access ControlConnecting RS232 Connecting & Configuring Serial Ports for Pan/Tilt/ZoomConnecting Serial Port Connecting RS485Configuring Serial Port Connecting USB Device Trimming WireWDR-516S Installation Guide Rev 1.093/11 IEEE1394 Bay Connecting External StorageConnecting IEEE1394 Device Available HDDRegistering & Formatting HDD Connecting Ethernet Network Monitoring & ManagingConfiguring WDR-516S’s Network Information PC System Requirements for running WDR Manager Using WDR ManagerInstalling WDR Manager WDR-516S Installation Guide Rev 1.093/11 Configstation Uninstalling WDR ManagerMonitor PlaybackAppendix Compatible HDD Appendix #1 Installing and Replacing internal HDDInstalling & Replacing Screw 6EA TOP Cover Installing single HDD Installing 2 HDDs HDD Cable WDR-516S Installation Guide Rev 1.093/11 Hi-Z N on Video type / impedance setup switchAppendix #2 Video Input Preparation Appendix #3 Using CD-ROMComponents of CD- ROM disc Reading manual of CD-ROMImage Compression Appendix #4 SpecificationGeneral NetworkEnvironment Data Backup/Expansion/CopyDisplay Input/OutputElectricity PTZ ControlOthers Dimension WⅹDⅹH Weight MechanicalWDR-516S Installation Guide Rev 1.093/11