Philips DVD580M owner manual Putting Batteries in the Remote Control, Using the Remote Control

Putting Batteries in the Remote Control

1 Remove the battery compartment lid on the back of the remote control by pressing in the tab, then lifting off the lid.

2 Place two AA batteries inside the battery compartment with their + and – ends aligned as indicated. Do not mix old and new batteries or different types of batteries (standard, alkaline, etc.).

3 Replace the battery compartment lid as shown at right.

Using the Remote Control

Always point the remote control directly at the remote sensor (IR or infrared) on the front of the Player, not the TV. Details are on page 18. Make sure there are no barriers between the remote control and the Player.

Connecting the Base

A base is provided with the Player to add stability and to allow you to posi- tion the Player horizontally or vertically, whichever fits your setup situation best. To connect the base, follow these steps.

1 Use a coin to loosen the screw on the base.

2 Decide whether you want to attach the Player to the base vertically or horizontally. Turn the Player vertically or hori- zontally, then find the screw hole in the Player that you need to use.

If you want to attach the Player to the base horizontally, use the screw hole that is just below the COAXIAL and OPTICAL jacks.

If you want to attach the Player to the base vertically, use the screw hole that is to the right of the MULTI-5.1 jack.

3 Place the Player on the base so the screw aligns with the hole on the Player. Insert and tighten the screw to secure the Player to the base. Use a coin to tighten the screw.

Hookups (cont’d) 15

Remote Sensor (IR)

Horizontal Attachment

Pr	Pb
	Y
	S-VIDEO	VIDEO
12V			C
			OAXIAL	O	FL	SL
				PTICAL			CENTER
								MULTI-5.1
					FR
						SR
							SUBW.
						MULTICHANNEL
							AUDIOOUT

Vertical Attachment

12V		Pr
		Pb
		Y
		S-VIDEO
		VIDEO
		COAXIAL
		OPTICAL
MULTICHANNELAUDIOOUT	FR SR SUBW.	FL SL CENTER MULTI-5.1