Philips DVD795SA owner manual Receiver Example only

Hookups (cont’d) 15

Connecting to a TV and to a Six-channel Receiver (Dolby Digital or DTS)

Back of TV

(example only)

VIDEO IN

MULTICHANNEL AUDIO IN SURROUND SUB WF FRONT

R

L

SURROUND

Receiver

(example only)

2-4

6

1 5

1 Connect the supplied yellow video cable to the Player’s yel- low CVBS (VIDEO OUT) jack and to the corresponding VIDEO IN jack on the TV. There are two CVBS (VIDEO OUT) jacks if you want to connect the Player to two separate TVs. To connect the Player to one TV, use either of the jacks, but not both.

2 Connect the Player’s CENTER jack to the Receiver’s CEN- TER IN jack.

Connect the Player’s SUB WF. jack to the Receiver’s SUB- WOOFER IN jack (or directly to the Subwoofer if possible).

3 Connect the Player’s right/left FRONT jacks to the right/left FRONT IN jacks on your Receiver.

4 Connect the Player’s right/left SURROUND jacks to the right/left SURROUND IN jacks on your Receiver. Your Receiver may refer to Surround as Rear. These are the same.

5 Set the Player’s Progressive/Interlace switch to Interlace.

6 Connect the power cords of the Player, TV, and Receiver to a power outlet.

Press STANDBY-ON y on the Player to turn on the Player. The red Standby light will disappear.

7 Turn on the TV and set it to the correct Video In channel. Refer to your TV manual. Or, go to your lowest TV channel, then change channels down until you see the Player’s blue screen saver on the TV.

8 Turn on your Receiver and set it to the correct Audio In channel or sound source. Refer to the Receiver’s manual.

9 Set Analog Output to Multi-channel. Details are on page 44. Adjust the Speakers if necessary. Details are on page 45.

Helpful Hints

•Cables for the connections to the Receiver are not supplied with the Player.

•You may use S-Video or Component Video connections instead for higher picture quali- ty. These options must be avail- able on your TV. Details are on pages 11-12.