Philips DVD795SA Analog Output, Press 9 to select Analog output, then press . Analog out

44 Analog Output

If you connected the Player’s red and white AUDIO OUT or FRONT MULTICHANNEL AUDIO OUT jacks to a Stereo as shown on page 13, or if you connected the Player to a six-channel Receiver as shown on page 15, choose a setting for Analog Output.

Check your Stereo or Receiver and see if it is compatible with Dolby Surround. Then, follow these steps to choose the Analog Output setting that is most compatible with your equipment.

POWER

2

DISC DIM T-C SOUND MODE

1 2 3

1	Press SYSTEM MENU.	will be selected.	7	8	9	1,5
			4	5	6
2	Press 9 repeatedly to select G, then press :.		2-4RETURN	0	DISPLAY
	Press 9 to select Analog output, then press :. Analog out-			É	SYSTEM
					MENU
3 put may be selected already. If so, just press : to continue.			É	OK	É
	Press 8 or 9 to select Stereo, Dolby Surr-compat (Dolby			É
	Surround compatible), 3D sound (surround sound effect),		G		H
4 or Multi-channel, then press OK.
			STOP	PLAY	PAUSE
	● Select Stereo if your audio equipment is not compatible with		Ç	É	Å
			SUBTITLE ANGLE ZOOM		AUDIO
	Dolby Surround, or if you connected the Player to a TV only
	or to a Stereo with Right/Left Audio In jacks. When you play		REPEAT	REPEAT SHUFFLE SCAN
	Discs that were recorded in Dolby Digital 5.1, the sound will			A-B

be mixed into the appropriate Stereo sound that will be acceptable by your two-channel TV or Stereo.

●Select Dolby Surr-compat (surround compatible) if your Stereo is compatible with Dolby Surround. If it is, usually a Dolby Pro Logic logo will appear on the equipment.

●Select 3D Sound if you did not connect any rear or surround speakers to the Player, but still want the effect of surround sound.

●Select Multi-channel if you connected the Player to a six- channel Receiver as described on page 15. Multi-channel is the preset factory setting.

The Multi-channel setting means the Player’s sound will be in Dolby Digital 5.1 or DTS when available on the Disc. Dolby Pro Logic decoding will be available on DVDs or Video CDs that were recorded in Stereo. Dolby Pro Logic decoding is not available with SACDs.

	Z	Y		d
	1en	1en	1	st
	Digital output
	Analog output		spStereo
G	Night mode		Dolby Surr-compat
	Clear Voice		3D sound
r	Speakers		Multi-channel

PCM Output

CD Upsampling

5 Press SYSTEM MENU to remove the menus.

Helpful Hints

• Set Analog output simply in the System Menu Bar during DVD or Video CD playback. Press SOUND MODE to select d. Within five seconds, press 8 or 9 to select st, sur, 3d, or 6ch.

• If you set Analog output to Multi-channel, adjust the speak- ers as described on page 45.

• Multi-channel and Stereo sound cannot be available at the same time.