HCD-PX333
SERVICE POSITION
•In checking the MD mechanism deck section
Part No.
•In checking the CD mechanism deck section
Connect extension jig
BD (MD) board (CN103) and MD DIGITAL board (CN1004).
MD mechanism deck section
CN103
CN102
BD (MD) board
CD mechanism deck section
BD (CD) board | CN101 |
|
Pin 2 (GND)
Connect extension jig
BD (MD) board (CN102) and MD DIGITAL board (CN1003).
CN1004
CN1003 | MD DIGITAL board |
|
CN1005CN1002
CN1005 | Connect extension jig |
| to the BD (CD) board (CN101) and |
MD DIGITAL board (CN1002).
Pin 3 (OUTSW)
harness
Note on Checking CD Mechanism Deck Section
In performing the operation check with the CD mechanism deck section removed from the main unit, the CD disc loading will be disabled if the connector cable between MD DIGITAL board (CN1005) and LOADING board (CN151) is disconnected. Accordingly, make preparation through the following steps.
1.Insert the CD disc for test with the set assembled.
2.Unplug the AC power cord to turn the power off, and remove the CD mechanism deck section. (Disconnect the connector cable between MD DIGITAL board (CN1005) and LOADING board (CN151), and also the connector cable between MD DIGITAL board (CN1002) and BD (CD) board (CN101))
3.Connect the CN1005 pin 3 (OUTSW) and pin 2 (GND) on the MD DIGITAL board with a lead wire.
4.Connect the connectors between MD DIGITAL board (CN1002) and BD (CD) board (CN101) with the extension tool (part No.:
Note 1: Under this condition, the CD can be played but the disc loading operation is disabled.
Note 2: After checking, disconnect the lead wire connected in step 3.
8