Setup
Setup is used to: |
| ||
| • | Install channels | EN |
| • | Test signal level and quality | |
| • | modify the general settings of your receiver | |
| • | check for software updates | |
| • | restore the receiver factory settings. |
|
Access to this menu can be protected by Pin Code. |
| ||
Channels installation |
| ||
- | Select appropriate values for the following: |
| |
| • | Network ID: applicable network ID as indicated |
|
|
| by your operator. See operator booklet for the |
|
| • | right decimal value to be entered for your region. |
|
| Frequency: broadcast frequency predefined or |
| |
|
| entered manually as indicated by your operator |
|
| • | (see operator booklet). |
|
| Symbol Rate: predefined or entered manually as |
| |
| • | indicated by your operator. |
|
| Modulation: modulation type predefined or |
| |
|
| entered manually as indicated by your operator. |
|
|
| Symbol rate and modulation values should not be |
|
|
| modified unless requested by your operator. |
|
- | Press OK to start scanning for channels. |
| |
Signal Test
Signal Test is used to view the signal level and quality for the frequency defined at installation.
TV Configuration
Select appropriate values for the following:
• TV Format: 4:3 or 16:9
• TVCenteraspect ratio: full format, 16:9 Letter Box, 4:3
• TV output signal: CVBS, RGB, or S Video
• TV audio signal: Stereo, Mono, or Dolby Digital.
• VCR Video Output: CVBS or S Video
• RECORD,orVCR ec ding control: NO, PREPARE RECORD LINK. See chapter More
about recording (VCR or DVD control).
• Video mode: PAL or SECAM - Press OK to store the settings.
61