Philips PHDVR8L owner manual Setup

Page 5

Button Functions, cont.

Audio Functions (labeled in Red)

PRESET Used to operate preset channels while in Audio Mode.

AM/FM Lets you to select the AM/FM band on your audio receiver.

CD,TAPE,TUNER,TV,VIDEO 1, andVIDEO 2 Used to select your audio receiver’s input source. (Works in AUDIO Mode, i.e. after pressing Red AUDIO button).

FUNCTION Selects the different audio input devices. The number buttons also select the function labeled above the buttons when in AUDIO Mode. LEVEL+/LEVEL - Sets the level of the speakers during test tone Mode.

DSP ON/OFF Enables the receiver’s Digital Signal Processing (DSP) Mode.

DSP MODE When the DSP Mode is enabled, pressing this button lets you cycle through the various DSP Modes.

PROG Lets you program the playback order of tracks on your disc.

DELAY - and DELAY+ Increases or decreases the delay between the surround and main speakers when your receiver is in the surround sound Mode.

ON/OFF, SURR, MODE ON/OFF SURR toggles the surround Modes on and off. SURR MODE cycles through your receiver’s various surround sound Mode settings.

F, C, R, T (Front, Center, Rear, and Test) Adjusts the levels of the front, center, and rear speakers respectively. Used with Level + /Level - . The test tone must be enabled first by pressing the TEST button.

TV/VCR/DVR

When in TV mode the TV/VCR/DVR button performs the INPUT source switch function.

When in a mode that has been programmed for VCR the TV/VCR/DVR button performs the TV/VCR antenna switch function.

When in a mode that has been programmed for Cable the TV/VCR/DVR button performs the A.B switch function. When in a mode that has been programmed for SAT the TV/VCR/DVR button performs the TV/SAT switch function.

When in a mode that has been programmed for DVD the TV/VCR/DVR button performs the DVD Setup function.

8

Setup

Battery Installation

1. On the back of the remote, push down on the tab and lift the cover off.

2.Match the batteries to the + and - marks inside the

battery case, then insert 2 AAAAlkaline batteries.

3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are depressed more than 30 seconds. This will save your batteries should your remote get stuck in a place where the buttons remain depressed (e.g., between the sofa cushions).

Code Saver

Codes are stored in permanent memory while you are changing batteries so you will not lose any codes stored in the remote while you are changing batteries.

Power-On Default

The remote powers on in TV mode.

Code Setup

The CODE SEARCH button is used to setup the remote. You can either setup the remote using the code for your brand of product, from the code tables (on separate sheet), or you can search through the library of codes until you find a code that works for your product.

Please refer to “Code Search” on page 10 for more information on using the code search feature to learn how to search through the library of codes for your products.

NOTE: You can store any kind of code under any mode (except TV). I.E. you can store a VCR code under the CBL button, or a DVD code under the VCR button, etc. However, you can only store TV codes under the TV button.

9

Page 4 Page 6
Image 5
Page 4 Page 6
Contents PHDVR8L Introduction Table of ContentsButton Functions Button Functions, Volume UP/DOWN Changes the volume levelSAT Functions DVD Functions labeled in BlueTivo/Replay Functions labeled in Green TiVo code is Replay code isSetup Code Search by Brand Direct Code Entry Code Search,Code Search Code Identification Feature Sleep Timer Programming Combo Device Codes Setup,Code Learning Setting ALLVolume/Mute Control to any one ModeTips On Learning, IR Transmitter Finder FeatureClearing Commands Learning CommandsTo Clear all Learned Commands under a mode Master Clear To Clear all Learned Commands under all modesMacros To Setup a MacroMacros, Macro NotesLimited Lifetime Warranty TroubleshootingIntroducción ÍndiceFunciones de botones Replay el código es Funciones de DVD con leyendas en azulFunciones de audio con leyendas en rojo PreparaciónInstalación de baterías Ahorrador de bateríasProgramacíon con Búsqueda de codigos Preparación,Ingreso Directo de Códigos Cronometro de apagado automático Función de Identificación de CódigosControl de equipos combinados Códigos de programación de equipos combinadosConsejos Para el Aprendizaje Preparación, Transferencia de códigosConsejos Para el Aprendizaje, Aprendizaje de Comandos Despejando Comandos Cómo programar una macro Programación de una macroBorrado de macros Notas sobre las macrosEl Control Remoto no Opera Algunas Funciones de su Aparato El Control Remoto no Opera su ProductoTable des matières Fonctions des touches Fonctions des touches, Certaines touches de la télécommande peuvent avoir desFonctions SAT DVD Functions labeled in BlueFonctions TiVo/ReplayTV en vert TiVo code ReplayTV codeInstallation des piles ConfigurationFonctions audio en rouge Économiseur de pilesProgrammation au moyen de la fonction de recherche des codes Configuration suiteMinuteur de mise en veille Fonction d’identification des codesAccès direct aux modes VCR/DVD/DVR Contrôle des combinésConseils Sur L’Apprentissage Configuration suite Apprentissage de codesConseils Sur L’Apprentissage suite Pour Effacer Toutes Les Commandes Enregistrees Sous Un Mode Commandes D’EnregistrementSuppression des commandes Pour supprimer une macro Pour enregistrer une macroLe témoin clignote une fois le code programmé DépannageGarantie a vie limitée
Top Page Image Contents