4 Using your HD receiver
4.1Standby/wake up
To put your HD receiver into standby, press on your HD receiver’s front panel or remote control.To take your HD receiver out of standby, press again.You can also press BACK , P+/P- or any number button on your remote control to wake up your HD receiver.
See page 6 for more information.
4.2Switching on and off
Use the ON/OFF switch on the rear panel of your HD receiver to switch your HD receiver on/off. See page 6 for more information.
4.3Changing channels
To change channels, use the P+/P- on your remote control or your HD receiver’s front panel.You can also use the number buttons on your remote control.
Press BACK to switch to the last channel you were watching.
You can also use the
Note
Initially, HD programmes are available only on channels 50 and 51. Switch to these channels to watch HD programmes.
4.4Adjusting volume
To increase or decrease the volume, press
To mute or restore the sound, press .When you mute your sound, the icon is shown in the top right corner of your TV.This icon disappears after a few seconds.
4.5Using the channel banner
Channel information
When you change a channel, the channel banner appears briefly to show information about the current programme. By default, it appears for
5 seconds.To set the length of time that the channel banner remains
Note
While recording a programme to an external recording device such as a VCR, the channel banner overlay will not be recorded.
Changing channel
To change the channel, display the channel banner by pressing INFO.
When the channel banner is
To display more information about the current programme on the channel listed in the channel banner, press INFO again.
E N G L I S H
Using your HD receiver | 13 |