Your HD receiver locates the software available on your USB memory stick and displays a confirmation message. Press the green button to install the software immediately. Press the red button to cancel and return to the previous menu. If you press the green button, your HD receiver updates the software and restarts.You may, depending on the update, then be required to complete the first installation setup (see page 10).
Restoring factory default settings 
From the Settings menu, use 
/ 
to
highlight 
or OK. In the
use 
/ 
to highlight Factory reset and press OK twice.
A message appears asking you to confirm. If you are sure, press the green button, or press the red button to cancel and return to the previous menu. If you press the green button, your HD receiver restores the factory default settings and restarts.You will then be required to complete the first installation setup (see page 10).
Note
Resetting your HD receiver to the factory default settings erases all of your preferences and settings. For example, all of your favourite lists and recording timers will be erased.
Changing other system settings
From the Settings menu, use 
/ 
to highlight 
or OK. The
To turn on or off the channel updates that automatically happen when your HD receiver is in the 
or OK. Press 
to highlight Automatic update and press 
or OK. Use 
/ 
to highlight On or Off.
Press 
or BACK 
to save your changes and return to the previous menu.
To check the signal quality of any channel that you are receiving, press 
to highlight Signal quality and press 
or OK.
In the Signal quality test menu that appears, use 
/ 
to select a channel that you want to check. Press 
or BACK 
to return to the previous menu.
To turn on or off powering your active- indoor antenna using the Antenna IN connector on the rear panel of your HD receiver, press 
to highlight Antenna powering and press 
or OK. Use 
/ 
to highlight Off or On.
Press 
or BACK 
to save your changes and return to the previous menu.
26 | Using more of your HD receiver |