Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you move the unit to a different area after the initial setting, or if you restore the DTV channels you deleted, it is recommended to use AutoProgram to perform a new channel search.
1 Press
(MENU) to display Home Menu and use ▲▼ to select Setup, then press OK.
2 Use ▲▼ to select Autoprogram, then press OK.
3 Use ▲▼ to select Cable or Antenna, then press OK. 4 Press OK to select Start now.
•Autoprogram will start automatically.
21 English
Channel list
You can make a list of your preferred TV channels so that you can find those channels more easily.
1 Press 
(MENU) to display Home Menu and use ▲▼ to select Setup, then press OK.
2 Use ▲▼ to select Channel list, then press OK.
Picture | Highlight channels for Ch Up/Down key | DTV 1.2 |
| selection. | ATV 10.0 |
Sound |
| |
|
| |
|
| DTV 10.1 |
Setup |
| |
| DTV 10.2 | |
Features |
| |
| ATV 66.0 |
Picture Sound
Setup
Features
USB
Autoprogram
Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete.
59% |
|
Digital Channels | 7 CH |
Analog Channels | 0 CH |
USB |
|
|
|
| BACK |
Navigate | OK Watch / Skip | Back |
3 Use ▲▼ to select the desired channel, then press OK repeatedly to switch between skip/watch.
• The greyed out channels indicates exclusion, which means those |
channels will be skipped when using CH + / CH − key (on your |
BACK
Exit
5 Follow the
Note
•After setting Autoprogram, using CH + / CH − skips unavailable programs automatically.
•If you are not receiving a signal from your cable service, contact the cable provider.
•If you press 
or during Autoprogram, the setup of TV channels will be canceled.
•Even if Autoprogram is completed, the channel setting will be lost if the AC power cord is unplugged before the unit goes into Standby mode by pressing 
.
• The PIN code will be required once you set a PIN code in the Child lock. | p. 23 |
• If you want to change your PIN code, follow the instruction of Change PIN. 
p. 25
TV remote control) for channel browsing. |
• The white channels indicates inclusion, which means those |
channels will be shown when using CH + / CH − key (on your |
TV remote control) for channel browsing. |