Philips DVP3200V/37B user manual Turn on the TV, Repeat this process if the power fails

16 First-time DVD/VCR Setup

Before turning on your DVD/VCR, make sure batteries are in the remote control and the DVD/VCR and TV are connected correctly. You cannot program channels if you are using a Cable Box or a Satellite Receiver.

These menus may not appear if you have already turned on the DVD/VCR.

1 Turn on the TV. Set it to channel 3 or 4 or its AUDIO/VIDEO IN channel, depending on how you connected the DVD/VCR to a TV.

2 Press VCR, then press y. VCR light will appear on the front of the DVD/VCR. The display shown below will appear. These menus may not appear if you have already turned on the DVD/VCR. You may have turned on the DVD/VCR before to find the Audio/Video In channel of the TV, for example. If so, follow the steps on page 21 to set up channels and page 23 to select a language for the VCR menus.

LANGUAGE SELECT

E8A21UD_EN1 5/29/06 3:13 PM Page 16

English

BENGLISH[ON]

FRANCAIS

ESPAÑOL

PUSH B

3 Press K or L to select ENGLISH, FRANCAIS (French) or ESPAÑOL (Spanish) as the language for VCR On-Screen Displays and menus. Then, press B. The display shown below will appear.

1 Turn on the TV.

2

TV/VIDEO	VCR	DVD	VCR Plus+
SUBTITLE	AUDIO	ANGLE	ZOOM
DISC/VCR			DVD
MENU			SETUP

OK 3-4

BACK

		DISPLAY
REW	PLAY	FFW
PREV	PAUSE	NEXT
REC		STOP
REPEAT		+
	TIMER SET	CH
REPEAT		-
A-B

CLEAR
REC MODE SEARCH	MODE	TITLE

AUTO SET UP

PUSH B

4 Press B to begin channel programming. AUTO SET UP will flash on the TV screen during the Channel Search. The DVD/VCR will memorize all available channels.When channel programming is complete, the lowest available channel will appear on the TV.

These channels will be available when you want to watch TV while in VCR mode. To put the DVD/VCR in VCR mode, press VCR so VCR light appears. Use CH + or CH - to select memorized channels. To select non-memorized channels, use the Number buttons.

Helpful Hints

•To skip this feature and play a tape immediately, insert a tape with its record tab removed.

•If you like to skip step 4, press DISC/VCR MENU as soon as the search begins. The DVD/VCR will stop the Channel Search, and the VCR menus and displays will be in English.

•If you try to program channels when there is no antenna or Cable TV signal connected to the ANT-IN jack of the DVD/VCR, programming will stop. AUTO SET UP will stop flashing. Connect an antenna or Cable TV signal to the DVD/VCR’s ANT-IN jack and press B again.

•Repeat this process if the power fails.