Philips DVP3200V/37B user manual One-Touch Recording, Stopping an OTR

Page 26

E8A21UD_EN1 5/29/06 3:13 PM Page 26

26One-Touch Recording

English

One-Touch Recording (OTR) lets you set a timed recording 30

 

minutes to 8 hours long of the current TV channel. Before you

1

begin:

● Place the DVD/VCR in VCR mode. Press VCR so VCR light

appears on the front of the DVD/VCR.

● Select a recording speed (SP, SLP) by pressing REC MODE. ● Put a videotape in the cassette compartment. Make sure the

tape’s record tab is intact and the tape is long enough to record the program(s).

TV/VIDEO

VCR

DVD

VCR Plus+

SUBTITLE

AUDIO

ANGLE

ZOOM

DISC/VCR

 

 

DVD

MENU

 

 

SETUP

Press VCR, then press CH + or CH - or the Number

 

 

OK

 

 

 

 

 

 

 

1 buttons to select the channel you want to record.

 

BACK

 

DISPLAY

 

Press REC I repeatedly until the desired recording

 

REW

PLAY

FFW

 

 

 

 

 

length (30 minutes to 8 hours) appears on the TV

 

 

 

 

 

2 screen. Recording will begin. “REC” and “ ” will appear

2

PREV

PAUSE

NEXT

 

on the DVD/VCR’s display panel.

 

REC

STOP

 

 

REPEAT

 

+

1

OTR (0:30)

 

 

TIMER SET

CH

 

 

REPEAT

 

-

 

 

A-B

 

CLEAR

SP

When an OTR ends

The DVD/VCR will turn off and “” on the DVD/VCR’s display panel will flash indicating that the recording is complete, then goes into the timer standby mode again. (It may switch to DVD mode automatically.) At this point, you cannot use the VCR unless you release the DVD/VCR from the timer standby mode.

To release the DVD/VCR from timer standby mode

●If the DVD component is active and no more timer recordings are on standby, you can cancel the timer standby mode by pressing TIMER SET or VCR on the remote control or by pressing SOURCE or STOP/EJECT C A on the front panel.

●If the DVD component is not active, or the “” is not flashing but lit indicating there are more timer recordings on standby, you can cancel the timer standby mode only by pressing TIMER SET on the remote control or by pressing STOP/EJECT C A on the front panel.

●After releasing the DVD/VCR from timer standby mode, you can use it as usual.

Stopping an OTR

To stop an OTR before recording is finished, press STOP C on the remote control or STOP/EJECT CA on the front of the DVD/VCR. To cancel the OTR but continue recording, press REC I repeatedly until REC appears in the upper left corner of the TV screen, and “” disappears.

Helpful Hints

•The remaining recording time will appear on the display panel during an OTR. Press DISPLAY to see it on the TV screen.

•To change the recording length while an OTR is in progress, press REC I repeatedly.

•You cannot pause an OTR.

•If the preset time for a timer recording comes up during an OTR, the OTR has priority. The timer recording will not take place.

•If the end of the tape is reached during an OTR, the VCR will stop recording, eject the tape, and switch to DVD mode or turn off.

•If one or more Timer recordings are on standby when one OTR ends, the DVD/VCR

will turn off automatically and “” will appear on the DVD/VCR’s display panel indicating that it is now ready for another timer recording.

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Necesita ayuda Inmediata? Need help fast?Besoin d’une aide Rapide? Proof of Purchase For Customer UseImportant Safety Instructions Declaration of Conformity Safety Information cont’dSafety Precautions BoxTable of Contents Introduction Playable Discs and Video Cassettes Hookups Determining the best possible connection1Antenna or Cable TV Signal Hookups cont’dRemember Signal RF coaxial cableConnections Cable SignalDVD/VCR RF coaxial cable TV’s AntennaComposite or Baseband video Jack of your DVD/VCRDVD/VCR Audio OUT jacks on the DVD/VCR and to the red Video OUT jacks on the DVD/VCR and to the ComponentCheck your Stereo manual for details Antenna/Cable TV SignalDVD/VCR to a TV and a Stereo Back of TV Example only1Antenna/Cable TV Signal Recycling Guidelines/Battery Safety Putting Batteries in the Remote ControlUsing the Remote Control Repeat this process if the power fails Turn on the TVVideo Cassette Playback On the DVD/VCRDisc Playback VCR Display Panel Display PanelDVD Display Panel Display MessagesFront Panel Front Panel, Rear Panel and Remote ControlRemote Control Rear PanelAdding/Deleting Channels Channel SetupPress s or B to switch ADD/DELETE To scan through only the memorized channels, use CH + or CHWhile the DAY space is flashing, press K or L until Clock VCRPress VCR, then press DISC/VCR Menu so MENU1 While the Year space is flashing, press K or LPress Display again to remove all the displays Press Clear to remove the menuEnglish Remove Cover Tab to prevent Videotape RecordingRecording Prevention RecordingPress TV/VIDEO once to put the DVD/VCR in TV Remote control to return to channel 03 or 04 atPress TV/VIDEO on the DVD/VCR remote control To put the DVD/VCR in VCR position. The VCR lightOne-Touch Recording Stopping an OTRMake the connections shown above Point the remote control at DVD/VCR 2. PressRerecording Tape Duplication Turn on the TV and set it to channel 03 or 04Timer Recording When a timer recording ends Timer Recording cont’dOn for the timer recording Cancelling a Timer Recording before the Recording StartsPut the DVD you want to copy in the disc tray Be possible only if the DVD is not copy protectedDVD Press REC I to start recording. REC will appear onBox/DBS output channel for every Guide channel ChannelsInstructions continue on the next Guide CH User CHSteps Instructions from the previousTell the VCR the Guide and User channels by following Examine the lists onPress the Number buttons to enter the PlusCode Press VCRPress VCR Plus+ Then, press VCR Plus+Press K or L until your desired tape speed appears Press K or L until your desired channel numberAppears. Then, press B Press ClearPress Timer SET for the recording Repeat Playback Tape CounterTime Search Index SearchAutomatic Operation Features Special Effects PlaybackMulti-Channel Television Sound Multi-Channel Television Sound/Hi-Fi StereoUnderstanding Displays Hi-Fi StereoPlayback Control PBC Function Using the Title MenuMenus, Playback Control PBC Function Press K, L, s or B to select an item, then press OKX1.3 and x0.8 Rapid Play with Voice To resume normal playback, press Play BTitle/Chapter/Time Search Title/Chapter SearchTrack Search Resume On Paused and Step-by-Step Playback, Resume OnPaused and Step-by-Step Playback Repeat To cancel A-B Repeat, press Repeat A-B. OFF willRepeat, A-B Repeat Let you start over OFF will appear briefly onElapsed playing time will appear beneath the Markers MarkersScreen Display will disappear in about 30 seconds, or pressDVD SubtitlesCamera Angles Audio Language Audio Language, Stereo Sound ModeStereo Sound Mode Press Pause F during DVD, Video CD or DivX Playback Slow MotionZoom Press Play B to return to normal playbackRandom Playback Program/Random PlaybackProgram Playback To stop playback, press Stop C When you put a CD-R or CD-RW with MP3MP3/Windows MediaTM Audio/JPEG Playback Press DISC/VCR Menu during MP3/JPEG playback Dual PlaybackFolder Playback Press K or L to select a folder, then press Play B or OKPress K or L to select the desired group folder or DivX PlaybackDivX Subtitle Hint Play BDVD Displays Press DVD to put the DVD/VCR in DVD modeOn-Screen Displays Video CD and Audio CD DisplaysDuring Windows Media TM Audio playback Press Display or Back to remove the displayBlack Level Black Level,Virtual SurroundInitializing Virtual SurroundLanguage OriginalDisc Menu Language cont’dLanguage Codes KinyarwandaPress s or B to select DISPLAY, then Press OK Select a setting, then press OKDisplay Press K or L to select an item, then press OKProgressive Scan Default setting is OFFDisplay cont’d Jacks. Choose OFF otherwiseIf you selected DRC, press OK repeatedly to AudioPress s or B to select Custom at the top Turn Dynamic Range Control DRC On orPress DVD to put the DVD/VCR in DVD mode. DVD While playback is stopped, press DVD/SETUPPassword CHANGE, then press OK Press s or B to select CUSTOM, then press OKParental Levels Rating ExplanationsPress s or B to select Default setting is onOthers Others cont’d Default setting is 5 secPress DVD/SETUP to remove the menus Glossary Cable Box/Satellite Receiver Output Channel 03 orHelpful Hints Helpful Hints cont’d Cleaning the Video Heads DVD/VCR ejects the tape when you press REC I or Timer SETLine input mode You cannot insert a video cassetteCare and Maintenance Limited Warranty Philips Limited Warranty ONE 1 YearInformation Index Memo
Top Page Image Contents