Set the Start Mode item in the menu to “Manual” ac-
cording to the procedure on
☞ Page 18 “Start the encoding automati- cally”.
Start the encoding manually
Operation Flow Chart
Press the ENTER button
Main Menu screen will be displayed.
Press the 8 / 9 buttons
Select the Configuration Menu and press the ENTER button.
Press the 8 / 9 buttons
Select the Operate Param Menu and press the EN- TER button.
Press the 8 / 9 buttons
Select the Start item and press the ENTER button.
Press the ENTER button
This starts the encoding.
Display Flow Chart
Main Menu
+ C o n f i g u r a t i o n M e n u
C o n f i g u r a t i o n M e n u + O p e r a t e P a r a m M e n u
O p e r a t e P a r a m M e n u V i d e o R a t e : 2 0 0 0 0 k b p s
O p e r a t e P a r a m M e n u >Start?
Memo
The encoding will stop if menu item has been changed dur- ing manual encoding and “>Save&Reboot” has been excecuted.
Start the encoding manually once again.
operation
Stop the encoding manually
Operation Flow Chart
Press the ENTER button
Main Menu screen will be displayed.
Press the 8 / 9 buttons
Select the Configuration Menu and press the ENTER button.
Press the 8 / 9 buttons
Select the Operate Param Menu and press the EN- TER button.
Press the 8 / 9 buttons
Select the Stop item and press the ENTER button.
Press the ENTER button
Stop the encoding.
Display Flow Chart
Main Menu
+ C o n f i g u r a t i o n M e n u
C o n f i g u r a t i o n M e n u + O p e r a t e P a r a m M e n u
O p e r a t e P a r a m M e n u V i d e o R a t e : 2 0 0 0 0 k b p s
O p e r a t e P a r a m M e n u >Stop?
Basic
19