Configuration Menu
: Default setting
Item | Setting value | Content |
|
|
|
Initial Param
Menu
Control Mode | Local |
| Remote |
Set the operation mode of this unit.
Local : Set to this mode when operating this unit using the buttons on the front panel.
Remote : Set to this mode when using
| Start Mode | Auto | Set the starting mode of encoding. | |
|
| Manual | Auto | : Start the encoding automatically. |
|
|
| Manual : Start the encoding using the menu. | |
|
|
| ☞ Page 18 “Starting the Encoding” | |
|
|
|
| |
| Sync Mode |
| Set the synchronized signal that is the reference for encoding. | |
|
| REF | ||
|
|
| REF | : Synchronize with the D1 signal input into |
|
|
|
| REF IN terminal @ on the rear panel. |
|
|
|
| |
| TS Rate | 10000kbps | Set the TS bit rate. | |
|
| to | The setting value can be changed in 10 kbps step. | |
|
| 21000kbps |
|
|
|
| to |
|
|
|
| 50000kbps |
|
|
|
|
|
| |
| Video Mode | 1080i | Set the Video Mode. | |
|
| 720p | Encode with 1080i: 1080i format. | |
|
|
| Encode with 720p: 720p format. | |
|
|
|
| |
| Audio Format | MPEG | Setting the Audio Format. | |
|
|
| MPEG : Encoding with MPEG Layer 2. | |
|
| (Dolby™ Digital Pass | ||
|
| Through) | Dolby™ Digital bitstream will be output in TS | |
|
|
| Format. | |
|
|
|
| |
| Audio Input | AES/EBU | Select the input audio signal. | |
|
| EMB | AES/EBU : Encode the audio signal input into AES/EBU | |
|
|
|
| terminal # on the rear panel. |
|
|
| EMB | : Encode the Embedded audio signal |
|
|
|
| input into |
|
|
|
| rear panel. |
|
|
|
| |
| Audio ExDelay | 1ms | This setting is meant for compensating the delays | |
|
| to | introduced when encoders are connected to | |
|
| 10ms | external equipment. | |
|
| to | (Denary, Millisecond unit) | |
|
| 500ms | Setting value is 1 ms step variable. | |
|
|
|
| |
| Audio Enable | ON | Set whether to output audio signal or not. | |
|
| OFF | ON | : Output audio information. |
|
|
| OFF : Does not output audio information. | |
|
|
|
|
|
Memo |
|
When input video sig- |
|
nal is used in synchro- |
|
nized mode, video sig- |
|
nal may not output for |
|
about 20 seconds due | setting |
cable. | |
to switching of signal or |
|
reconnection of signal |
|
Memo | Menu |
|
The setting value of the Video Rate item in the Op- erate Param Menu may change if TS Rate setting value is changed.
Memo
The setting value of the Asp item in the Operate Param Menu may change if Video Mode setting value is changed.
Memo
This setting is only valid when Audio Format is set as
13