Setting up the massage lounger
1 Where to use the unit
Ensure there is adequate space to recline.
Caution
•Do not use the unit in areas with high humidity, such as the bathroom, because this can lead to electric shock or other accidents.
•Place the unit on a totally flat surface.
Failure to do so may result in the unit tipping over.
•Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of a heater, etc., as this can cause discoloration or hardening of the synthetic leather.
•Place the unit on a mat to prevent floor damage.
•When placing a mat under the unit, the size of the mat should be sufficient (at least 47 × 28 in. (120 × 70 cm)) to cover the areas where the unit touches and where the legrest could touch the floor, as shown in the diagram on the right.
•Install the unit near a power outlet.
Keep at least 4" (10 cm) away from the wall.
Approx. 77" (195 cm)
Width approx. 33" (84 cm) Approx. 12" (30 cm)
Approx. 14" (35 cm)
Mat
|
|
|
|
|
|
|
|
|
|
Area where legrest | Area where unit | |||
could touch the floor | touches the floor | |||
2 Removing everything from the box and installing the unit
• Use care to prevent lower back and other injuries that could occur when lifting this heavy object (approx. 176 bs. (80 kg)). (The unit must be carried by two persons.)
• When using the wheels to move the unit, place a mat on the floor to protect the floor surface.
To put the unit down on the floor
•Put the unit down slowly and carefully watch your step.
•Put down the legrest by holding it with your hands until it has been set on the floor completely. If you release your hands before the legrest is fully extended, the legrest will forcefully return to the initial position.
Fabric Section 
| Place your | Groove |
Hold the cloth |
| |
fingers in the |
| |
section on the | groove |
|
underside |
|
|
Legrest | Back cover | Mat |