Panasonic EP30006 Problem Cause and Remedy Unit will not operate at all, Unit has been damaged

Page 49

Problem

 

Cause and Remedy

 

The unit will not operate at all.

 

• The power cord has been disconnected. (See page 16)

• Upper body (neck to lower back) massage

 

• The power switch on the unit has not been turned on.

• Lower body (calves to seat) massage

 

• A Pre-Program button or Manual Operation button hasn’t

• Arm massage

 

 

been pressed after pressing

.

 

 

 

 

 

 

 

Sometimes the power won’t turn on when

is pressed

Approximately 5 seconds are required for program termination

after a massage finishes. Wait at least 5 seconds once all

again when a massage has finished.

 

 

 

movement has stopped before pressing

.

 

 

 

 

 

The unit has been damaged.

 

Stop using the unit immediately.

 

 

The power cord or power plug is abnormally hot.

Stop using the unit immediately.

 

 

Warning

•Do not attempt to repair, disassemble or modify the unit.

Failure to observe this precaution may result in fire or injury due to malfunctioning.

Caution

•Unplug the power plug immediately and contact a customer service center to arrange for repairs if the unit ceases to function or is otherwise not working properly.

Failure to observe this precaution may result in electric shock or fire.

SPECIFICATIONS

Power supply

Power consumption

 

Massage area (Up-Down)

Upper

Massage area (Left-Right)

Massage area (Forward-back)

body

Massage speed

massage

Lateral/Vertical Travel

 

 

Massage width

Air massage

Air Pressure (Calf)

 

Reclining angle

Automatic Shut-off

Dimensions

When not reclined

(H × W × D)

 

(H × W × D)

 

When reclined

Weight of Unit

Dimension of box (H × W × D)

Weight in box

Maximum user weight

Minimum distance from wall

AC 120 V 60 Hz

195 W

Approx. 30 in. (76 cm) (The massage heads move a total of approx. 26 in. (65 cm))

Distance between massage heads during operation (massage width adjustable) Neck, Shoulder, Back, Lower back: Approx. 3 – 8 in. (7 – 21 cm)

Projected amount of massage head (Intensity adjustable)

Approx. 4 in. (10 cm)

Tap: Approx. 250 – 450 cycles/minute (single side)

Full roll: Approx. 26 – 92 seconds (both ways)

Other than the above: approx. 6 – 50 cycles/minute

Lateral travel: Approx. 1.5 in. (3.8 cm) left-right auto return

Vertical travel (Long): Approx. 30 in. (76 cm) up-down auto return

Vertical travel (Short): Approx. 4 in. (10 cm) up-down auto return

Full roll, Vertical Movement: Approx. 3 – 7 in. (7 – 18 cm)

Other than the above: Same as massage area (left-right)

5:Approx. 32 kPa

4:Approx. 30 kPa

3:Approx. 25 kPa

2:Approx. 19 kPa

1:Approx. 8 kPa

* It may vary with the area slightly.

Backrest: Approx 120˚ – 170˚

Legrest: Approx 0˚ – 85˚

Automatically turns off after approx. 15 minutes (approx. 5 minutes for the quick massage)

Approx. 47.2 × 33.1 × 50 in. (120 × 84 × 127 cm)

Approx. 28.3 × 33.1 × 76.8 in. (72 × 84 × 195 cm)

Approx. 181 lbs. (82 kg)

Approx. 28.3 × 30.7 × 65.4 in. (72 × 78 × 166 cm)

Approx. 216 lbs. (98 kg)

Approx. 264 lbs (120 kg)

15.7 in. (40 cm)

48

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Operating Instructions Instrucciones de Uso Important Safety Instructions Safety Precautions Operating Precautions Grounding Instructions Main unit Part names and functionsBack Control Panel Self-Program Setting Display Voice Guidance Volume DisplayTime Remaining Display During massage Ultra Knead/Repeat DisplayWhere to use the unit Setting up the massage loungerRemoving everything from the box and installing the unit To put the unit down on the floorWidth Approx 68 cm Height Approx 66 cm Length Approx 160 cm AccessoriesConnecting the air plugs AssemblyAttachingarmrests Attaching the control panel stand covers Configuration When removing the control panel stand coverRaising the backrest to the upright position Gap Flat-tip ScrewdriverPlacing the control panel into the control panel stand Attaching the pillow Inserting the shoulder plateShoulder plate Pocket Attach the pillow to the velcro fastenersSwitching on the power supply Check the power cord and the power plugBefore sitting down Check the unitWhen the massage heads are not in the retracted position Pre-Program and Quick Massage Characteristics Upper Body Press the button to turn on the powerProgram Massages Press one of the flashing buttons To select ProgramBody scanning will commence when the program is selected During a massage When the massage startsOverview of the Pre-Program and Quick Massage Upper Body Open the right cover and press the button Creating Self-ProgramsSelf-Program Self-ProgramPress the button to start the program Setting the Time and IntensityTo change the time and intensity in the middle of a massage Massage SequenceManual Operation Manual Selection MassagesManual Operation Select the massage action Select the location you want to massagePress Button to start the action Body scanning for Manual OperationUltra Knead Shiatsu Swedish For additional operationsAdjusting the speed Adjustments During a MassageChanging the program Changing the massage styleAdjusting the position Adjusting the intensityAdjustment of range of intensity Width Adjustment LimitsDetails about the massage style Range that can be massaged on the upper bodyOpen the left cover Adjusting the intensityTo execute the air massage only Adjust the legrest so that your feet fit snugly Adjusting the Legrest lengthFor the foot reflexology plate Arm Massage How to use the hand/arm massageInsert the hand all the way inside Center of the armrest Adjustments for the seat/thigh massage Adjustments for the Shoulder MassageOuter Shoulder Massage Operations of the leg stretch Using the stretch massageOperations of the arm stretch To execute the stretch massage onlyOttoman and Backrest height adjustment Legrest slide lever Press Button to adjust the volume Adjusting the voice guidance volumePress the button to shift the volume level by one up/down Adjusting the control panel stand Adjusting the control panel stand and pillowAdjusting the pillow for correct height during a massage When the selected button starts flashing quickly Saving the user program settingsPress the button used to save your settings Advanced user memory functionFor Pre-Program, Quick Massage, and Self-Program Settings that can be savedFor Manual Operation Erasing saved data Press the button to turn on the power After completing the massage When the massage is completeEmergency Stop Press the button Keep the lock switch key out of reach of children Disconnecting the powerAreas covered with synthetic leather Cleaning and MaintenanceWipe these areas with a soft, dry cloth Lifting the Unit Moving the Unit Do not move the unit while someone is seated in it Using the wheels to move the unit Massage heads stop during operation Problem Cause and Remedy Motor NoisesMassage heads do not come up to the shoulder or NeckSometimes the power won’t turn on when Is pressed Problem Cause and Remedy Unit will not operate at allAgain when a massage has finished Power cord or power plug is abnormally hotPanasonic Consumer Electronics Company
Top Page Image Contents