User Manual V2IU 4350 Converged Network Appliance
Protocol
Display and set the T1 Layer 2 protocol. Supported protocols are:
•HDLC
•Cisco HDLC
•PPP
•ANSI (Frame Relay)
•CCITT (Frame Relay)
1.Select the desired T1 protocol.
2.Press Submit.
Frame Relay Mode and DLCI
When the Protocol is one of ANSI or CCITT, then additional Frame Relay configuration parameters are required.
The Frame Relay Mode is usually set to DTE for the customer premises.
The Frame Relay DLCI is set by the WAN provider and identifies the
Most installations will use a single DLCI for both voice and data traffic. However, in instances where the network will provide a different quality of service based on DLCI number it is desirable to place all voice traffic on one DLCI and then configure a second DLCI for data. In this case, the Secondary DLCI is configured as follows:
1.Select Network.
2.Select the T1 link next to the radio button to proceed to the T1 configuration page.
3.Select Enable in the Frame Relay Secondary Settings section of the page.
4.Enter the Secondary DLCI, IP Address, Network Mask and Gateway for the data traffic using the Secondary DLCI.
3 - 18