Polycom V2IU 4350 user manual Enabling a Read-only User

Configuring the V2IU 4350

Note	The new password must be between 6 and 20 characters in length. Any
	combination of alpha and numeric characters is accepted.

1.Enter the password you chose in step C again in the Confirm Password to ensure that there were no mistakes in the initial entry.

2.Press Submit.

Read-only User

This feature works by creating a new user with read-only access to the system. All information is displayed in a non-changeable form. Information changed in entry boxes cannot be submitted. In fact, most Submit and OK buttons are not visible.

Note: You must have administrator privileges and log in as an administrator to change read-only user.

Enabling a Read-only User

To enable a read-only user, use the following steps:

1.Using the configuration graphical user interface, from the Configuration Menu on the left-hand side, click Network.

Note: You must have administrator access and log in as an administrator to change read-only user.

2.Scroll down to the area of the screen shown below.

3.Click changed. The following window screen appears:

3 - 25